Panasonic PVC2023 PVC2023 User Guide - Page 8

Connections/Initial Setup (Ready to Play) Please make all cable or antenna connections before power on. Connecting For ANT./Cable Connect the cable from Antenna/Cable to the VHF/UHF terminal on the unit. UNIT (rear view) For DSS/Cable Box Connect the OUT jack on your cable box to the VHF/UHF terminal on the unit with a RF cable. WARNING: Overtightening "Nut type" RF coaxial cables may damage jacks. Finger tighten only. Initial Setup (Ready to Play) Press COMBO on the remote for Combo mode. 1 Plug the unit power cord into AC wall outlet. 2 Press POWER on the remote or unit. The unit comes on and auto channel and clock set starts. • If you use a cable box, turn it on and set it to the Public Broadcasting Service (PBS) channel in your time zone. If you use a DSS receiver, it must be turned off. CH AUTO SET PROCEEDING VHF/UHF VHF/UHF VHF/UHF UNIT (rear view) IN from ANT./CABLE Cable TV Converter Box VHF/UHF VHF/UHF VHF/UHF IN from ANT./CABLE If AUTO CLOCK SET IS INCOMPLETE screen appears, set the clock using MANUAL CLOCK SET procedure on next page. AUTO CLOCK SET IS INCOMPLETE PLEASE SET CLOCK BY PRESSING ACTION KEY AUTO CLOCK SET PROCEEDING CANCEL : STOP 3 Settings are made automatically. When setup is done, this screen appears. 2/ 6/2003 THU 12:00PM DST : ON SETT ING : CH 10 AUTO CLOCK SET COMPLETED Notes • Function buttons are inoperative during Initial Setup. • To remove a cassette during Auto Set, press EJECT twice on the remote or STOP twice on the unit. In this case, settings must be made manually. (See page 10.) • Depending on conditions, Auto Clock Set may take longer than 30 minutes. If so, press STOP to stop setup and perform settings manually. (See page 10.) 8 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]