Panasonic PVDV103D Digital Video Camera - Page 44
Memory-Stop Editing Optional, Remote Control Only, DISPLAY, SETUP, Optional
View all Panasonic PVDV103D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Editing Features 4, 5PAUSE 4 Press (PAUSE) to start Audio Dubbing. "A.DUB " indication appears. • Connect the Palmcorder to the TV in order to monitor the sound. (p. 37) To listen to the desired audio sound, set the 12bit AUDIO setting of the VCR mode MENU (Menu OSD: p. 67) as follows: 12bit AUDIO:The following selections are available for 12 bit AUDIO dubbed recordings only (sound recorded in SP mode only). ST 1 ST 2 MIX Set this position to listen to the original sound. Set this position to listen to the audio dubbed sound. Set this position to listen to both the original sound and the audio dubbed sound. Note • When a 16 bit recording is dubbed over, the original audio of the recording will be erased. • When a 12 bit recording is dubbed over and played back, and MIX is selected as the AUDIO, both the original audio and the dubbed audio are played back. • If you recorded in LP mode, you cannot use the A.DUB feature. Only NTSC (National Television Standards Committee) recorded tapes can be audio dubbed. The following screen appears if the tape was not recorded in NTSC format. 5 Press (PAUSE) to stop Audio Dubbing. • If the microphone used for dubbing gets too near the speaker of your TV, a howling noise (feedback) may occur. • If the tape position is in or was started in a blank section, you cannot use the A.DUB feature. A Memory-Stop Editing (Optional Remote Control Only) Press MENU to display the VCR FUNCTIONS menu screen. You can set an automatic Dubbing stop point. B Rotate JOG KEY to select DISPLAY Optional SETUP , and then press JOG KEY C to display the DISPLAY SETUP menu. Rotate JOG KEY to select C. DISPLAY , and then press JOG DRESET AMENU KEY to set to MEMORY. D Press MENU to exit MENU mode. Then, press RESET on the remote control to reset the Counter Memory to M 0:00.00. Now, rewind to the editing start point, and continue with steps 2-5. The tape will now stop automatically at "M 0:00.00". 44 Forassistance,pleasecall:1-800-211-PANA(7262)orsende-mailto:[email protected]