Panasonic SC-BTX70 Blu-ray Receiver - Page 10

Connections to a Set Top Box, etc, Radio antenna connections

Page 10 highlights

Getting started Connections to a Set Top Box, etc. Use the following connections when you want to output the original surround audio from your Set Top Box, cable TV, VCR, DVD recorder, etc. through this unit's speakers. ≥Do not connect through the video cassette recorder. Due to copy guard protection, the picture may not be displayed properly. ≥Turn off all equipment before connection. STB, VCR, DVD recorder, etc. TV OPTICAL OUT Refer to the operating instructions of the respective devices for the optimal connections. OPTICAL 2(STB) Optical digital audio cable (not included) TIPS ≥This unit can decode the surround signal from the Set Top Box (Satellite receiver, Cable box, etc.). Press [EXT-IN] several times to select "D-IN 2" (DIGITAL IN 2*). * "(CABLE/SAT)" is displayed next to DIGITAL IN 2 when set for CABLE/SAT AUDIO input. (> 25, Setting the TV audio for VIERA Link "HDAVI Control") ≥For connections between this unit and the TV, refer to "TV connections". (> 9) ≥If you have various sound sources and this unit's terminals are not sufficient, connect them to the available inputs on the TV and the TV output should then be connected to the "AUX" or "OPTICAL 1(TV)" terminal of the main unit. Refer to the operating instructions of the TV, video cassette recorder, DVD recorder or Set Top Box for settings to output its audio via AUDIO OUT or OPTICAL OUT terminal of the TV. - In some cases the audio signal will only be output as 2ch audio from the TV. In this case, connect the Set Top Box (Satellite receiver, Cable box, etc.) that will be used most commonly with multi-channel audio to this unit's "OPTICAL 2(STB)" terminal. Main unit Radio antenna connections ≥Keep loose antenna cables away from other wires and cables. 1 FM Indoor antenna FM Main unit 75Ω ANT Using an FM indoor antenna FM indoor antenna (included) Affix this end of the antenna where reception is best. Adhesive tape 1 Using an FM outdoor antenna Use outdoor antenna if FM radio reception is poor. ≥Disconnect the antenna when the unit is not in use. ≥Do not use the outdoor antenna during an electrical storm. FM outdoor antenna [Using a TV antenna (not included)] The antenna should be installed by a competent technician. * Rework your outdoor antenna's 75 Ω coaxial cable as follows.  Remove a piece of the outer vinyl insulator.  Carefully pull the tabs apart to remove the cover.  10 mm (13/32) 7 mm (9/32) 75 Ω coaxial cable*   (not included) Peel back 10 mm (13/32) Antenna plug (not included)  Install the coaxial cable. Clamp the cable conductor, and wind it on so that it does not contact anything else. FM 75 Ω ANT FM 75 Ω ANT RQT9479 10 Main unit Main unit Clamp with pliers  Attach the cover.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56

10
RQT9479
Connections to a Set Top Box, etc.
Use the following connections when you want to output the original surround audio from your Set Top Box, cable TV, VCR, DVD recorder, etc.
through this unit’s speakers.
Do not connect through the video cassette recorder.
Due to copy guard protection, the picture may not be displayed properly.
Turn off all equipment before connection.
Radio antenna connections
Keep loose antenna cables away from other wires and cables.
OPTICAL
OUT
OPTICAL 2(STB)
TV
Optical digital
audio cable
(not included)
STB, VCR,
DVD recorder, etc.
Refer to the operating
instructions of the respective
devices for the optimal
connections.
Main unit
This unit can decode the surround signal from the Set Top
Box (Satellite receiver, Cable box, etc.).
Press [EXT-IN] several times to select
D-IN 2”
(DIGITAL IN 2*).
* “(CABLE/SAT)” is displayed next to DIGITAL IN 2 when
set for CABLE/SAT AUDIO input. (
>
25, Setting the TV
audio for VIERA Link “HDAVI Control”)
For connections between this unit and the TV, refer to “TV
connections”. (
>
9)
If you have various sound sources and this unit’s
terminals are not sufficient, connect them to the available
inputs on the TV and the TV output should then be
connected to the “AUX” or “OPTICAL 1(TV)” terminal of
the main unit.
Refer to the operating instructions of the TV, video
cassette recorder, DVD recorder or Set Top Box for
settings to output its audio via AUDIO OUT or OPTICAL
OUT terminal of the TV.
– In some cases the audio signal will only be output as
2ch audio from the TV. In this case, connect the Set Top
Box (Satellite receiver, Cable box, etc.) that will be used
most commonly with multi-channel audio to this unit’s
“OPTICAL 2(STB)” terminal.
TIPS
FM
ANT
75
Ω
Main unit
FM Indoor antenna
1
Using an FM indoor antenna
Using an FM outdoor antenna
Use outdoor antenna if FM radio reception is poor.
Disconnect the antenna when the unit is not in use.
Do not use the outdoor antenna during an electrical storm.
Main unit
FM
ANT
75
FM
ANT
75
Antenna plug
(not included)
75
Ω
coaxial cable
*
(not included)
FM outdoor antenna
[Using a TV antenna
(not included)
]
The antenna should be installed by a
competent technician.
Main unit
Adhesive
tape
FM indoor antenna
(included)
Affix this end of the antenna
where reception is best.
1
*
Rework your outdoor antenna’s 75
Ω
coaxial cable
as follows.
7 mm (
9
/
32
)
10 mm (
13
/
32
)
Peel back
10 mm (
13
/
32
)
Remove a piece of the
outer vinyl insulator.
Carefully pull the tabs
apart to remove the cover.
Attach the cover.
Install the coaxial cable.
Clamp the cable conductor,
and wind it on so that it does
not contact anything else.
Clamp with pliers
Ω
Ω
Getting started