Panasonic SC-PMX9 SC-PMX9 Owner's Manual (English) - Page 3

Supplied accessories, Maintenance, Preparing the remote control - test

Page 3 highlights

THE FOLLOWING APPLIES IN THE U.S.A. AND CANADA This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that is deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated keeping the radiator at least 20 cm (7 7/8q) or more away from person's body (excluding extremities: hands, wrists, feet and ankles). THE FOLLOWING APPLIES ONLY IN CANADA This device complies with RSS-210 of the IC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, (2) This device must accept any interference received, including interference that may cause undesired operation of this device. THE FOLLOWING APPLIES ONLY IN CANADA CAN ICES-3(B)/NMB-3(B) THE FOLLOWING APPLIES ONLY IN CANADA The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance. THE FOLLOWING APPLIES ONLY IN THE U.S.A. FCC Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ≥ Reorient or relocate the receiving antenna. ≥ Increase the separation between the equipment and receiver. ≥ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ≥ Consult the dealer or an experienced radio/TV technician for help. Any unauthorized changes or modifications to this equipment would void the user's authority to operate this device. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Responsible Party: Panasonic Corporation of North America Two Riverfront Plaza, Newark, NJ 07102-5490 Support Contact: http://www.panasonic.com/contactinfo THE FOLLOWING APPLIES ONLY IN THE U.S.A. Caution! Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 0 Supplied accessories Check and identify the supplied accessories. 1 x AC power supply cord 1 x Remote control (K2CB2CB00022) (N2QAYB000896) 1 x FM indoor antenna (RSAX0002) 1 x Remote control battery 2 x Speaker cables (REE1840) Maintenance • To clean the main unit, wipe with a soft, dry cloth. • To clean the speakers, wipe with a fine-textured and dry cloth such as a microfibre cleaning cloth. • Never use alcohol, paint thinner or benzine to clean this system. • Before using chemically treated cloth, read the instructions that came with the cloth carefully. Preparing the remote control R6/LR6, AA • Use alkaline or manganese battery. • Install the battery so that the poles (+ and -) align with those in the remote control. 3 • Point the remote control at the remote control sensor, away from obstacles, at a maximum range of 7 m (23 ft) directly in front of the main unit, within an angle of approximately 30° to the left and right. VQT5J68

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21

3
VQT5J68
0
Supplied accessories
Check and identify the supplied accessories.
Maintenance
To clean the main unit, wipe with a soft, dry cloth.
To clean the speakers, wipe with a fine-textured and dry
cloth such as a microfibre cleaning cloth.
Never use alcohol, paint thinner or benzine to clean this system.
Before using chemically treated cloth, read the instructions
that came with the cloth carefully.
Preparing the remote control
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
Point the remote control at the remote control sensor, away
from obstacles, at a maximum range of 7 m
(23 ft)
directly in
front of the main unit, within an angle of approximately 30°
to the left and right.
THE FOLLOWING APPLIES IN THE U.S.A. AND
CANADA
This transmitter must not be co-located or operated
in conjunction with any other antenna or transmitter.
This equipment complies with FCC/IC radiation
exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency
(RF) Exposure Guidelines in Supplement C to
OET65 and RSS-102 of the IC radio frequency (RF)
Exposure rules. This equipment has very low levels
of RF energy that is deemed to comply without
maximum permissive exposure evaluation (MPE).
But it is desirable that it should be installed and
operated keeping the radiator at least 20 cm (7
7
/
8
q
)
or more away from person’s body (excluding
extremities: hands, wrists, feet and ankles).
THE FOLLOWING APPLIES ONLY IN CANADA
This device complies with RSS-210 of the IC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
(2) This device must accept any interference
received, including interference that may cause
undesired operation of this device.
THE FOLLOWING APPLIES ONLY IN CANADA
CAN ICES-3(B)/NMB-3(B)
THE FOLLOWING APPLIES ONLY IN CANADA
The device meets the exemption from the routine
evaluation limits in section 2.5 of RSS 102 and
compliance with RSS-102 RF exposure, users can
obtain Canadian information on RF exposure and
compliance.
THE FOLLOWING APPLIES ONLY IN THE U.S.A.
FCC Note:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
Any unauthorized changes or modifications to this
equipment would void the user’s authority to operate
this device.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Responsible Party:
Panasonic Corporation of North America
Two Riverfront Plaza, Newark, NJ 07102-5490
THE FOLLOWING APPLIES ONLY IN THE U.S.A.
Caution!
Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate the equipment.
1 x AC power supply cord
(K2CB2CB00022)
1 x Remote control
(N2QAYB000896)
1 x FM indoor antenna
(RSAX0002)
1 x Remote control battery
2 x Speaker cables
(REE1840)
R6/LR6, AA