Panasonic SCPM11 Cd Stereo System - Page 9

1 2 4 1 2 DEMO 3 / REW / 4 DEMO A DEMO B Before using Setting the time This is a 12-hour display clock. This example in the figure shows how to set the time for 4:25p.m.. Switch on the power. Press [CLOCK/TIMER] to select "CLOCK". Every time you press the button: CLOCK PLAY REC 3 Previous display (within 7 seconds or so) Press [g/REW/3] or [4/FF/f] to show the present time. Press [CLOCK/TIMER] to finish setting the time. The display will return to whatever was displayed before you set the time. To display the time when system is ON Press [CLOCK/TIMER] to select "CLOCK". The time will be displayed for about 5 seconds and then the display will return to whatever was previously displayed. Note The clock may lose or gain some time over a period. Readjust if necessary. / FF/ A Turning the demo function off If the clock has not been set, a demonstration of the display is shown when the unit is switched to standby. This function is set to on at the time of purchase. Press and hold [-DEMO] until "NO DEMO" is displayed. This display changes each time the button is held down. NO DEMO (off) ↔ DEMO (on). CD MANAGER AUTO OFF REV REC FWD EQ-ON B Auto-off function by remote control only When CD or tape is selected as the source To save power, the unit turns off if it is left unused for ten minutes. Note This function does not work if the source is tuner or AUX. Press [AUTO OFF]. "AUTO OFF" is shown on the display. To cancel Press [AUTO OFF] again to clear "AUTO OFF" from the display. For your reference The setting is maintained even if the unit is turned off. When the unit is turned on again, "AUTO OFF" is displayed and the unit functions as described above. "AUTO OFF" disappears from the display if either tuner or AUX is selected as the source but continues to function normally. "AUTO OFF" remains displayed if CD or tape is selected as the source. 9 RQT5706