Panasonic SLPD9 SLPD7 User Guide - Page 16

Specifications, AUDIO, PICKUP, GENERAL

Page 16 highlights

Specifications AUDIO No. of channels Frequency response Output voltage Dynamic range S/N Total harmonic distortion Wow and flutter DA converter Output impedance Load impedance PICKUP Wavelength GENERAL Power supply Power consumption Dimensions (WqHqD) Mass 2 (left and right, stereo) 2-20000 Hz, ±1 dB 2 V (at 0 dB) 92 dB 100 dB 0.007% (1 kHz, 0 dB) Below measurable limit MASH (1 bit) Approx. 1 kΩ More than 10 kΩ 780 nm AC 120 V, 60 Hz 9 W 430I125I374 mm (1615/16"I429/32"I1423/32") 4.5 kg (9.9 lb.) Power consumption in standby mode: 1 W Note Specifications are subject to change without notice. Mass and dimensions are approximate. THE FOLLOWING APPLIES ONLY IN THE U.S.A. CAUTION: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and re- ceiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Any unauthorized changes or modifications to this equipment would void the user's authority to operate this device. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Panasonic Consumer Electronics Company, Division of Matsushita Electric Corporation of America One Panasonic Way Secaucus, New Jersey 07094 http://www.panasonic.com © 2000 Matsushita Electric Industrial Co., Ltd. Printed in Singapore Panasonic Sales Company, Division of Matsushita Electric of Puerto Rico, Inc. ("PSC") Ave. 65 de Infantería, Km. 9.5 San Gabriel Industrial Park, Carolina, Puerto Rico 00985 Panasonic Canada Inc. En 5770 Ambler Drive Mississauga, Ontario L4W 2T3 www.panasonic.ca RQT5763-2P A1100TL2061

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

RQT5763-2P
A1100TL2061
Panasonic Consumer Electronics
Company, Division of Matsushita
Electric Corporation of America
One Panasonic Way Secaucus,
New Jersey 07094
Panasonic Sales Company,
Division of Matsushita Electric of
Puerto Rico, Inc. (“PSC”)
Ave. 65 de Infanter
í
a, Km. 9.5
San Gabriel Industrial Park, Carolina,
Puerto Rico 00985
Panasonic Canada Inc.
5770 Ambler Drive
Mississauga, Ontario
L4W 2T3
www.panasonic.ca
En
© 2000 Matsushita Electric Industrial Co., Ltd.
Printed in Singapore
Specifications
AUDIO
No. of channels
2 (left and right, stereo)
Frequency response
2
20000
Hz,
±
1
dB
Output voltage
2
V (at 0
dB)
Dynamic range
92
dB
S/N
100
dB
Total harmonic distortion
0.007% (1
kHz, 0
dB)
Wow and flutter
Below measurable limit
DA converter
MASH (1 bit)
Output impedance
Approx. 1
k
Load impedance
More than 10
k
PICKUP
Wavelength
780
nm
GENERAL
Power supply
AC 120
V, 60
Hz
Power consumption
9
W
Dimensions (W
q
H
q
D)
430
I
125
I
374
mm
(16
15
/
16
I
4
29
/
32
I
14
23
/
32
)
Mass
4.5
k
g
(9.9
lb.)
Note
Specifications are subject to change without notice.
Mass and dimensions are approximate.
Power consumption in standby mode: 1
W
CAUTION:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and re-
ceiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
Any
unauthorized
changes
or
modifications
to
this
equipment would void the user
s authority to operate this
device.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
THE FOLLOWING APPLIES ONLY IN THE U.S.A.