Panasonic TC-P42C1 Service Manual - Page 22
Remove the K-Board, Replace the plasma panel
UPC - 037988242320
View all Panasonic TC-P42C1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
4. Disconnect the connector (S2). 5. Remove the Power Button. 6. Remove the screw (×1 ) and remove the S-Board. 10. Remove the screw (×1 ). 11. Remove the claw (×1 ). 12. Disconnect the connector (K1) and Remove the K-Board from LED Panel. 7.19. Remove the K-Board 1. Remove the Cabinet assy. (See section 7.17.) 2. Remove the S-Board. (See section 7.18.) 3. Remove the screws (×5 ). 4. Remove the Glass holder bottom rear. 5. Remove the screws (×4 ). 6. Remove the Glass holder side (L, R). 7. Remove the screws (×7 ). 8. Remove the Glass holder top rear and the Glass holder top front. 9. Remove the Glass holder bottom front. 7.20. Replace the plasma panel 1. Place the new plasma panel on the flat surface of the table (covered by a soft cloth), with the plasma panel surface facing downward. 2. Attach the C1-Board and the C2-Board, connect the flexible cables (×8) from the plasma panel to the C1-Board and the C2-Board, and fit the flexible cable holders. 3. Attach the Hooks (left, right) and fit the Stand brackets (L, R) to the new plasma panel. 4. Place the plasma panel section on the servicing stand. 5. Attach the cabinet assy and each P.C.Board and so on, to the new plasma panel. *When fitting the cabinet assy, be careful not to allow any debris, dust or handling residue to remain between the front glass and plasma panel. 22