Panasonic WV-SF138 Installation Guide - Page 12
Precautions for installation
View all Panasonic WV-SF138 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Precautions for installation Panasonic assumes no responsibility for injuries or property damage resulting from failures arising out of improper installation or operation inconsistent with this documentation. This product is designed to be used indoors. This product is not operable outdoors. Do not expose the product to direct sunlight for hours and do not install the product near a heater or an air conditioner. Otherwise, it may cause deformation, discoloration and malfunction. Keep the product away from water and moisture. within the specified range (page 28) • Locations subject to vibrations that exceed the railway specifications (EN50155) • Locations subject to condensation as the result of severe changes in temperature (In case of installing the product in such locations, the dome cover may become foggy or condensation may be caused on the cover.) Installing place Contact your dealer for assistance if you are unsure of an appropriate place in your particular environment. • Make sure that the installation area is strong enough to hold this product, such as a concrete ceiling. • When this product and camera mount bracket are mounted on a ceiling or a wall, use the screws described in page 21. The screws that secure the product are not supplied. Prepare them according to the material and strength of the area where the product is to be installed. • Do not mount the product on a plaster board or a wooden section because they are too weak. If the product is unavoidably mounted on such a section, the section shall be sufficiently reinforced. Do not place this product in the following places: • Locations where a chemical agent is used such as a swimming pool • Locations subject to humidity, dust, steam and oil smoke • Locations where a radiation, an X-ray, a strong radio wave or a strong magnetic field is generated • Locations where corrosive gas is produced, locations where it may be damaged by briny air such as seashores • Locations where the temperature is not 12 Be sure to remove this product if it is not in use. Design and engineer the power supply system to turn on/off the power of this product. The product has no power switch. When installing the product, use a PoE hub equipped with the ON-OFF switch for servicing. Protection from lightning When cables are used outdoors, there is a chance that they may be affected by lightning. In this case, install a lightning arrester just before where the cables connect to the camera. Screw tightening • The screws must be tightened with an appropriate tightening torque according to the material and strength of the installation area. • Do not use an impact driver. Use of an impact driver may damage the screws. • When a screw is tightened, make the screw at a right angle to the surface. After tightening the screws or bolts, perform visual check to ensure tightening is enough and there is no backlash. Procure fixing screws separately. The screws that secure this product are not supplied. Prepare them according to the material and strength of the area where the product is to be installed.