Paradigm GO10SW Garden Oasis Subwoofer Manual - Page 9

WIRING & SUBWOOFER INSTALLATION Mono Setup Using 4 Conductor Burial Cable & Crown Amplifier GOSW10 NOTE: If using 4 conductor burial cable, cap any loose wires at the the last speaker installed to avoid short out and potential amplifier damage. Mono Mono Mono OR GOSW12 Mono Mono Mono Preparing the 4 Conductor Burial Cable 1. Starting with the first speaker and every speaker/ sub that comes after, create a loop approximately 6" in length. 2. Recommended: Use a wire tie (not included) to keep the wire loop intact and act as a strain relief. 3. Use a Round Cable Stripper to remove the outside protective cable jacket to expose the four color-coded wires. Separate the wire loops as shown. Wires for Subwoofer white (+) & green (-) Wires for Speaker red (+) & black (-) 4. Cut the white (+) and green (-) wires with cable strippers and strip off 1 inch (25.4mm) of insulation from the ends of the wires to expose the copper conductor. EN | 8