Paradigm Signature SUB 2 Manual - Page 25
Check Online for the Latest Version of PBK Software
View all Paradigm Signature SUB 2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
ROOM PLACEMENT & THE PARADIGM PERFECT BASS KIT™ (continued) c) A new search window will appear. Click 'Cancel' in the bottom right Positioning the Microphone corner to bring up a measurement window; d) On the menu bar at the top of the new window go to 'Help', then 'About.' The version number will be displayed. Make a note of it; IMPORTANT! During the measurement process, the mic must point toward the ceiling, positioned at ear level when you are seated. e) Once installation is complete, delete zip file and extracted folder. 1. Position microphone on or near the first position (see diagram, pg. 18). Remove cushions from seating, if necessary, to attain correct height. Check Online for the Latest Version of PBK Software To adjust the height of the telescoping stand, loosen the large black Go to http:///www.paradigm.com/PBK and check under 'Latest Software' section to see if a newer version of the software is posted. If your version is clamp in the middle of the stand by rotating it counter-clockwise; retighten once desired height has been achieved. up-to-date, simply restart the program and run PBK. Five listening positions are normally measured but this number can be To update the version do the following: a) Make sure the program is closed on your computer before downloading new version; increased to ten positions (see diagram, pg. 18)-the first position must be at or just in front of the central seating position. Positions 2 and 3 should be symmetric to the left and right of the center line. The same applies to the remaining positions. b) Download the latest version to your computer desktop; c) Right-click on the downloaded .zip file and extract to desktop; IMPORTANT: Even if your room has less than five seating positions, to ensure optimal sound, measurements must be taken from five different d) Open the extracted folder and double-click on 'Setup'. Software listening positions. Each position should be at least 2 feet (60 cm) apart. installation instructions will appear on your screen. Follow them; e) Once installation is complete, delete file and folder; f) Go to Start Menu and run PBK. 2. Set the microphone in the first position; 3. Before starting to measure, set the subwoofer's Gain control to its center detent position; set Cut-Off Frequency to Bypass; and set Phase control to '0'. After running PBK, these controls can be adjusted as necessary as you complete the setup of your system. See section 'Fine Tuning.' 20