Pentair IntelliCenter Control System High Power Wireless Link Kit Installation - Page 4

4 High Power Wireless Link Kit Overview The High Power Wireless Link consists of an indoor and outdoor 902-928 MHz wireless transceiver. Note: The wireless transceivers ship from the factory as a matched pair. The ID numbers on each transceiver must be the same number to function correctly. If needed, the transceivers must be replaced as a matched pair. For more information, call Customer Support 800.831.7133. Automation Control System: The High Power Wireless Link indoor and outdoor transceiver provide a wireless connection between the Internet and the IntelliCenter®, IntelliTouch® or EasyTouch® Control System Load Center (or Power Center) located at the equipment pad which eliminates hard wire connection from inside your home to the equipment pad. Installation Guide This Installation Guide provides installation instructions for the High Power Wireless Link kit. For information about ScreenLogic Interface operation, refer to the ScreenLogic Interface User's Guide (P/N 520493). High Power Wireless Link Kit Contents The following items show are included in the kit: Note: ScreenLogic Interface Protocol Adapter and Cable (purchased separately) Power Over Ethernet Module (Outdoor hardware) Outdoor Transceiver (Cable Restrainer) Manual NOTE (*): ID numbers on Indoor and Outdoor transceiver board must match Ethernet Cable High Power Wireless (15 ft.) Link PoE/Ethernet Cable Bundle (P/N 544425) Indoor transceiver and base AC Power Adapter Mounting hardware (screws and anchors) Cable (for connection to ScreenLogic® Interface Protocol Adapter (purchased separately) Outdoor Transceiver enclosure High Power Wireless Link Kit Four conductor communication outdoor cable (white - 15 ft.)