Pentair MasterTemp High Performance Pool and Spa Heaters Heater Wire Harness K - Page 4
Connect the Stack Flu sensor. Fig. 10
View all Pentair MasterTemp High Performance Pool and Spa Heaters manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
WIRE HARNESS REPLACEMENT INSTRUCTIONS (USA) 7. Install the bushing in the top of the control box. Use (Fig. 6) 10. Connect the Stack Flu sensor. (Fig. 10) FIG. 6. 8. Route the Red and Green wires into the Control Box through the bottom hole. Plug the Fireman's jumper into the terminal board. Install bushing. Note: The plugs are shown in the control box and the Fireman's jumper installed. (Fig. 7). FIG. 10. 11. Connect the Gas Valve. (Fig. 11). FIG. 7 9. If the heater has a legacy ICM, connect each wire from P/N 476204 wire adapter to its correct location labeled in the ICM. Otherwise, connect the multi-pin connector from the Wire Harness to lower right side of ICM as shown in Fig 8. FIG.11. 12. Connect the Blower assembly. (Fig. 12). FIG. 8. FIG.12. 4