Pentair Pentair Hydromatic SHEF Series Cast Iron Effluent Pumps Hydromatic SHE - Page 5

HYDROMATIC® SHEF45 HIGH HEAD EFFLUENT SPECIFICATION DATA Wholesale Products Page: H10465-5 Dated: January 2014 MODELS: SUBMERSIBLE SUMP/ EFFLUENT MODEL SHEF45 1.01 GENERAL Contractor shall furnish all labor, materials, equipment and incidentals required to provide Qty.) submersible centrifugal high head effluent pump(s) as specified herein. The pump model covered in this specification is the SHEF45. The pump furnished for this application shall be MODEL as manufactured by Hydromatic. 2.01 DESIGN CONDITIONS Each pump shall be rated _______ H.P., ________ volts, _______ phase,_______ hertz and operate at _______ RPM. 3.01 OPERATING CONDITIONS The pump shall deliver _______ U.S. GPM/LPS at feet/meters TDK, and handle a _______ inch solid. The curve submitted for approval shall state, in addition to head and capacity performance, solid handling capability, amp rating, and design impeller diameter. 4.01 CONSTRUCTION Each pump shall be of the sealed submersible type incorporating features normally found in pumps furnished for the residential market. These features include: A The pump volute and motor housing shall be high quality gray cast iron, ASTM A-48, Class 30. B The pump inlet shall be open and clear, without screening to provide access for effluent and septic tank solids. C All external mating parts shall be machined and Buna N, O-Ring sealed. D All fasteners exposed to the pumped liquid shall be 300 series stainless steel. E All power cords shall be water resistant UL or CSA approved, with double insulation and sized as a function of Amp. draw. 5.01 MOTOR AND SHAFT The stator, rotor and bearings shall be mounted in a sealed submersible type housing. Single phase motors shall be split phase with centrifugal switch and start capacitor. Full Load and Locked Rotor Amps as well as Start and Run winding resistance shall be tabulated for each pump.