Pentax 500FTZ Operation Manual - Page 28
camera/the
UPC - 027075032590
View all Pentax 500FTZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
SLAVE FLASH FUNCTION . • . The AF500FTZ comes equipped with a slave function which allows for wireless discharge of the flash in sync with either the camera's built-in flash or an external flash attached to the camera. Use this function when you wish to change the angle of discharge including when the main flash light is discharged over the subject. • When used as a slave unit, the flash unit only works in the manual flash mode. Procedure 1. Set the flash's main switch to [SL] . [M1/xx] and [SL] are displayed on the LCD panel. • By depressing the ADJUST button, the flash output intensity can be sex between 1/1 to 1/32. Adjust the flash output intensity depending on your requirements. 2. Adjust the zooming position according to your requirements and place the flash unit, considering the angle of discharge to the subject. • When the flash is used off-camera, ensure the flash signal contacts are not short-circuited, due ti to contact with a metallic object: otherwise, the flash unit will not function properly. 3. Find the guide number listed in the "Table of Guide Number" on page 16. Then, calculate the aperture based on the flash-to-subject distance. Example: With the zoom position at 28mm, flash-to-subject distance 4m and the film speed lSO100 • © Find the guide number 32 from the "Table C of Guide Numbers", when the flash output intensity is 1/1. ® 32 (guide number) divided by 4 (flash-to- subject distance) gives 8 (aperture). 4. Set the lens to the calculated f-stop. 5. Set the shutter speed to the flash-sync-speed or slower. 6. Make sure that the flash Ready lamp on the AF500FTZ is lit and the flash unit mounted on the camera/the built-in flash is charged before discharging the flash unit. 26