Pentax Spotmatic Spotmatic Manual - Page 11
loading
View all Pentax Spotmatic manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Film loading Avoid direct sunlight when loading your film. 1 Open the back by pulling out the re- wind knob until back cover snaps open. 2 Place the film cassette into the cas- sette chamber, and push back the rewind knob. Draw out the film leader and crease across one or two perforations back from the end of the leader. Insert the creased portion into slot of the take-up spool. 3 Advance the film by alternately turn- ing the rapid wind lever and releasing the shutter until both sprockets have properly engaged the film perforations. Close the back by pressing it firmly. 4 If the film is properly loaded, the re- wind knob will turn counter-clockwise when you advance the film by turning the rapid wind lever. Film type reminder dial r or' 7 q Use the film type dial to show what type of film is in your camera. Simply turn the dial so that the type of film in the camera is opposite the A mark. To check whether the camera is loaded, turn the film rewind knob clockwise. If it turns freely, the camera is not loaded. Setting ASA film speed The ASA film CO speed rating of all V Cn 35mm films is given in the data )- s po 0 o I ;-,.. sheet packed with each roll of film. The higher the ASA number, the more sensitive the film. Lift the out- er ring of the shutter speed dial and rotate it until the ASA number of your film is opposite the red index mark. Be sure to set your film speed on the shutter speed dial because the dial is connected to the exposure meter system. 9