Pfaff Tiptronic 1147 Owner's Manual - Page 9
Winding, bobbin, second, spool, needle
View all Pfaff Tiptronic 1147 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Winding the bobbin from a second spool (N) Disengage the sewing mechanism (see page 5), Swing the second spool holder toward the back. Push a small spool of thread and a small unreeling disc on it. Place a bobbin on spindle 119 and turn it so that pin P enters slot 0 (Fig. 0). Pull the thread from the spool, draw it through guide 125 and then into guide 127, as shown in the illustration, making sure the thread is positioned between the guide and tension spring R. From there pull the thread to the bobbin winder and wind it around the bobbin a few times. Push the bobbin winder toward the_right, press down the foot control pedal and wind the bobbin. The bobbin winder stops automa tically when the bobbin is full. Push the full bobbin toward the left and take it out, cutting the thread in thread cutter S. Re engage the sewing mechanism. Important: On Model 1067 the bobbin winder must be disengaged for sewing. On Model 1069, you can wind the bobbin during sewing. Load thread reel with diagonal cut for end of thread facing to right. Winding through the needle eye (0) Raise the sewing foot. The needle must be in its 'up' position. Disengage the sewing mechanism. Place a bobbin on spindle 119 4 6