Pfaff hobby 1010 Owner's Manual - Page 13

HEMMING Note: Hemmer foot can be purchased separately. TWIN NEEDLE 4 Note: Twin needle can be purchased separately 1. Raise the foot and the needle to its highest position. Replace the toot with the hemmer foot. 2. Fold over the fabric edge by about 3mm and place it under the foot. Secure the folded edge with a few stitches. Take out the workpiece and draw the hem into the hemmer foot t. pulling the threads. 3. Lower the foot and sew the hem. 4. During sewing fold the fabric to the left a little and allow it to run into the hemmer foot. 5. Make sure that the fabric does not move under the right half of the foot. The fabric must be fed in to the scroll of the hemmer sufficiently so that the workpiece edge runs freely through the groove under the foot. Only suitable materials can be used and some practice may be necessary to acheive best results. -21 - J Remove regular needle and insert twin needle. Thread both threads through the same path as for normal sewing. Separate threads before last thread guide above the needle. Insert one thread into the right needle of twin needle. Insert other thread into the left needle of twin needle. CAUTION:Do not set stitch width wider than number 2 setting. E,cceeding this will cause breaking of needle. EMBROIDERY Lower feed dog and move hooped fabric slowly to form the desired effect. See Page 13 drop teed -22-