Pfaff hobby 875 Owner's Manual - Page 8
Spulen, Bobinage, Avvolgere, spolina, Bobbin, winding
View all Pfaff hobby 875 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Spulen Hauptschalter einschalten, Den Faden von der Garnrolle in die Spulervorspannung 2 ziehen nach rechts führen und einige Male in Pteilrichtung urn die Spute wicketn. Dann den Fu13anlasser betatigen und spulen. 1st die Spule volt, bleibt sie stehen. Die voIle Spule nach links drücken, abnehrnen und den Faden abschneiden. Bobinage Mettre Ia rnachine en circuit a 'interrup teur general. Tirer le fit de Ia bobine dans Ia preten sion 2 du dévidoir, le coucher a droite et I'enrouler de quelques tours, dans le sens de Ia flèche, sur Ia canette. Agir sur Ia pédale du rheostat et bobiner. Des que Ia canette est pleine, le dévidoir s'arréte. Pousser Ia canette vers Ia gauche, Ia retirer et couper le fit. Avvolgere Ia spolina Inserire l'interruttore principale. Tirare it fib dat rocchetto nella tensione delbo spolatore 2, riportarto verso destra e avvolgerbo alcune volte in senso delta freccia attorno alla spolina. Quindi azio nare it reostato e avvotgere Ia spolina. Quando Ia spolina è piena si ferma da sola. Prernere Ia spolina piena verso sinistra, toglierla e tagliare it fib. Bobbin winding Switch on master switch. Pull thread from thread reel into thread retainer 2, lead to the right and wind a few times around the bobbin in the direction of the arrow. Then actuate the foot control and wind the bobbin. The bobbin stops as soon as it is full. Push the full bobbin to the left, remove it and cut off the thread. 6