Philips 1150X User manual - Page 16

30 ENGLISH 1 C 5 Place the shaver into the holder behind 2 the two clips (1) and press the shaver down to lock into place (2). The display on the shaver will indicate shaver is charging. C 6 Press the ON/OFF button on the Jet Clean System to start the cleaning cycle. The shaver display stops showing the charging indication. C 7 The cleaning light starts to blink and the shaver is automatically lowered into the cleaning solution. The shaver stops charging while it is being cleaned. ◗ During the first phase of the cleaning cycle, the shaver will automatically turn on and off several times while the shaver holder lowers and raises the shaver's position in the cleaning solution, removing all debris. The cleaning light will blink continuously throughout the C cleaning program. ◗ During the second phase of the cleaning cycle, the shaver holder moves the shaver to the drying position and the drying light will blink. This phase will take approximately 2 hours. The shaver will stay in one position until the end of the drying program. ◗ Do not press the ON/OFF button while the cleaning cycle is running. If this does occur, the cleaning cycle will stop and the shaver holder ENGLISH 31 will automatically move to the starting position. The cleaning cycle can be re-started by pressing the ON/OFF button once. ◗ If the power plug is disconnected before the cleaning cycle is complete, the shaver holder will remain in its current position. Reconnect the plug into the outlet or Jet Clean System and the shaver holder will automatically move to the highest position. The cleaning cycle can be re-started by pressing the ON/OFF button once. C NOTE: If the cleaning solution level drops below the minimum level during the cleaning cycle, the 'cleaning chamber empty' symbol will blink and shaver holder returns the shaver to the starting position, stopping the cleaning cycle. Unplug Jet Clean System from the outlet, remove shaver and refill canister (see "Preparing Jet Clean System for Use"). 8 When the entire cleaning cycle is complete and the shaver is hygienically clean, the shaver will be raised to the starting position and the display on the shaver will turn on indicating that the shaver is (re)charging. 9 Pull the shaver forward and lift shaver from Jet Clean System. ◗ If the shaver needs to be recharged, you can simply leave it in the Jet Clean System after cleaning and the shaver will automatically recharge.The display on the shaver will indicate the shaver is recharging.