Philips 15PF8946 Quick start guide (English) - Page 1
Philips 15PF8946 - 15" LCD TV Manual
View all Philips 15PF8946 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
LCD TV Thank you for purchasing this Philips LCD Television set. You are now the proud owner of a LCD TV set which promises full value to you as a customer. Before you proceed to install the LCD TV, please follow the steps and diagrams as shown to familiarise yourself with the correct and safe way of assembling the stand to the TV. ASSEMBLING THE STAND 1 2 ! Ensure you have the following before you assemble the stand : - Two screws (supplied with set) - One Screwdriver (not supplied) Place the set facing down on a protective sheet close to the edge of a flat surface. 23"/58cm 20"/51cm For the 20"/23" models, open back plate cover by gently pulling upwards. 17"/44cm 15"/39cm For the 15"/17" models, open back plate cover by sliding the plate cover downwards and then pull upwards. 3 4 Bottom of swivel base NOTE : No swivel (20"/23" models only) base for 15"/17" models 1 2 Align arrow to the center For swivelling of the stand to function properly, adjust the swivel base at the back of the stand until arrow is aligned in the center. Align the stand studs into the holes at the bottom of the set. Put in the screws (provided) into the 2 holes and tightened with a screwdriver. CAUTION : While putting in the screws, hold onto the stand. 23"/58cm 20"/51cm For the 20"/23"models, close back plate cover by gently pushing downwards. 17"/44cm 15"/39cm For the 15"/17" models, close back plate cover by sliding plate upward. Check the stand arm is rigid and properly installed. Place the set upright. INSTALLING LCD TV ON THE WALL If you intend to install the LCD TV on the wall. ensure you have the following : - Standard VESA 100 bracket for 15"/17"/20"/23" LCD TV (not supplied) and four spacers found in the accessory bag. Do the following when installing the LCD TV on the wall : 1 2 3 Ñ Spacer Ñ x 4 Ñ VESA Bracket does not fit Tighten VESA bracket to spacers If your VESA bracket does not fit into the slot at the rear of the LCD TV, proceed to make use of the four spacers provided. Note : If VESA bracket fits into the slot, you need not use the spacers. Screw the four spacers to the holes at the rear of the set. Ensure the spacers are properly tightened (torque of 1.2N-m or 1 lbf-in). 3139 125 32112 Place the VESA bracket on the spacers and tightened with the VESA bracket screws.