Philips 40PFL4775 User manual - Page 3

Important safety instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (i rs) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does no o your outlet, consult an electrician for replacement of the obsolete outlet. 10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11. Only use attachments/accessories s manufacturer. y the 12. Use only with the cart, stand, tripod, bracket, or table spec by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 13. Unplug this apparatus during lightning storms or when unused for long periods of time. 14. Refer all servicing to quali vice personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. Note to the CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. Example of antenna grounding as per NEC National Electric Code GROUND CLAMP ANTENNA LEAD IN WIRE ELECTRIC SERVICE EQUIPMENT ANTENNA DISCHARGE UNIT (NEC SECTION 810-20) GROUNDING CONDUCTORS (NEC SECTION 810-21) GROUND CLAMPS POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PART H) Wall mount bracket kit Brand 70" 55" 43" SANUS 40" Model # Screw dimension VLT6-B1 M6 x 1.378" (35 mm) M4 x 1.378" (35 mm) ● Your TV meets the VESA standard for wall mounting. Consult with your local dealer for a wall mount bracket which is compatible with your TV model. ● The recommended wall mount bracket kit (sold separately) allows the mounting of the TV on the wall. ● For detailed information on installing the wall mount, refer to the wall mount Instruction book. ● Funai Corporation is not responsible for any damage to the product or injury to yourself or others if you elect to install the TV wall mount bracket or mount the TV onto the bracket on your own. ● The wall mount bracket must be installed by experts. Funai Corporation is not liable for these types of accidents or injuries noted below. ● Install the wall mount bracket on a sturdy vertical wall. ● If installed onto a ceiling or slanted wall, the TV and wall mount bracket may fall which could result in a severe injury. ● Do not use screws that are longer or shorter than their speci�ed length. If screws too long are used this may cause mechanical or electrical damage inside the TV set. If screws too short are used this may cause the TV set to fall. ● Do not fasten the screws by excessive force. This may damage the product or cause the product to fall, leading to an injury. ● For safety reasons use 2 people to mount the TV onto a wall mounting bracket. ● Do not mount the TV onto the wall mounting bracket while your TV is plugged in or turned on. It may result in an electrical shock injury. When installing the unit on the wall, allow this much space. Top : 11.8" (30 cm) Left and right side : 5.9" (15 cm) Bottom : 3.9" (10 cm)