Philips 44PL952S User manual - Page 10

Connecting a VCR 1 Connect the incoming antenna or cable TV signal to the ANT IN jack on the back of the VCR. 2 Using a coaxial cable, connect to the OUT jack on the back of the VCR and to the TUNER jack on the back of the TV. 3 Using A/V cables, connect from the AUDIO and VIDEO OUT jacks on the back of the VCR to the corresponding AV2 audio (L and R) and video (V) jacks on the back of the TV. Back of TV AV4 AV3 SUB OUT AV2 MON AV1 SERVICE 12C OUT G S-VIDEO R L V Pr Pb Y R L V R L V G S-VIDEO AV5 AV6 DVI 3 R L R L RGB+HV R L STANDARD/ HD INPUTS STANDARD/ HD INPUTS R L Pr Pb Y Pr Pb Y Incoming Cable TV or Antenna Signal 2 TUNER 4 Press the Source Select button on the remote control to access the Source list. 5 Press the Cursor Up or Down button to select the AV2 input source. 6 Press the OK button to confirm your choice. The set is now switched to the AV2 input source for the viewing of programs from the VCR. TV AV1:None Source OK AV2:None AV3:None AV4:None AV5:None AV6:None SIDE:None AUDIO L OUT IN R VIDEO ANT OUT IN OUT IN CH3 CH4 Back of VCR (example only) 1 NOTE: Since you've connected the cable TV signal directly to the TV's tuner (step 2 above), you can watch the unscrambled programs by simply tuning to the desired channel. To store channels in the TV's memory, you must use Autoprogram, which you can access through "Install" in the TV's on-screen menu. See the Autoprogram section in the Quick Use and Setup Guide that came with the TV. If you use Autoprogram, you can select channels by pressing the CH + or - buttons on the TV remote control (in TV mode). Otherwise, you must press the digit (number) buttons to tune directly to the channel you desire. HELPFUL HINT Color Coding Used on Jacks and Plugs to simplify connections: Yellow: Video (Composite Video) Red: Right Audio White: Left Audio. 45 6 5 ACITVE SOUND CONTROL PICTURE 1 2 ZOOM 10