Philips 50PFL5604 User manual - Page 57
Switching on your TV and putting it in, standby mode, Adjusting volume, Switching channels
View all Philips 50PFL5604 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
3 Use your TV Switching on your TV and putting it in standby mode TV Switching channels Remote control 17 .English * Key on rear Remote control Turns the TV on and off of standby. ● Press B POWER on the TV or the remote control. Note(s) ● Energy consumption contributes to air and water pollution. When the AC power cord is plugged in, your TV consumes energy with a very low standby power consumption. Adjusting volume TV To select channels by using CH + / - ● Press CH + / - on the TV or the remote control. To select channels by using the NUMBER buttons Digital TV operation ● For digital channels, press a number followed by a dot "•" and the corresponding sub channel number. - When selecting digital channel 1 1. 1 Be sure to press • before entering the subchannel number. Cable / NTSC (Analog) TV operation - When selecting cable or analog channel 1 1 * Key on rear Remote control Note(s) ● To select the non-memorized channels, use the NUMBER buttons. ● No signal will appear on the TV screen after the subchannel broadcast is over. To decrease or increase volume ● Press VOL + / - on the TV or the remote control. VOL + : Volume up VOL - : Volume down To mute or unmute sound ● Press 2 (MUTE) on the remote control to mute the sound. ● Press 2 (MUTE) again or VOL + / - to recover the original sound. Continued on next page.