Philips 65PFL5704 Quick start guide - Page 10

Category, Problem

Page 10 highlights

Category Network Picture Problem Cannot connect the network. Power is on but screen image is off. Tip • Check if your router and/or modem is properly connected. • Check if the Ethernet cable connection between the TV and your router or modem is properly secured. • Power cycle the router and/or modem. • Check your network settings. • Check if the connection for your source device is properly secured. • Check if the correct input is selected by pressing w (INPUTS). • Verify that your HDMI mode, for the input selected matches the resolution output of your source device. Change source input until you have picture and sound. For further assistance, call the customer support service in your country. - To obtain assistance, contact Philips customer care center; In the U.S.A., Canada, Puerto Rico, or the U.S. Virgin Islands 1 866 309 5962 Enter below the model and serial numbers located on the left side and the rear of the TV cabinet. Model : Serial : 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26

10
For further assistance, call the customer support service in your country.
-
To obtain assistance, contact Philips customer care center;
In the U.S.A., Canada, Puerto Rico, or the U.S. Virgin Islands
1 866 309 5962
Enter below the model and serial numbers located on the left side and the rear of the TV cabinet.
Model :
Serial
:
Category
Problem
Tip
Network
Cannot connect the
network.
Check if your router and/or modem is
properly connected.
Check if the Ethernet cable connection
between the TV and your router or modem
is properly secured.
Power cycle the router and/or modem.
Check your network settings.
Picture
Power is on but screen
image is off.
Check if the connection for your source
device is properly secured.
Check if the correct input is selected by
pressing
w
(INPUTS)
.
Verify that your HDMI mode, for the input
selected matches the resolution output of
your source device.
Change source input until you have
picture and sound.