Philips 65PFL5922 User manual - Page 21
Installation, is completed, a message will appear if there is
View all Philips 65PFL5922 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
9 Use to select Antenna for TV channels or Cable for CATV channels, then press OK. Installation Make sure that you have attached your antenna or cable signal into the jack on the back of your TV labeled "ANTENNA IN". Antenna Cable Skip Now select either Antenna or Cable, using up/down key of the remote control. Once you have made your selection, press the 1 23 OK button to proceed. 4 -When Antenna is selected, the TV detects antenna signals. It searches for DTV and analog TV channels available in your area. -When Cable is selected, the TV detects signals supplied by cable. It searches for DTV, analog TV and cable channels available in your area. • Auto programming will begin. After an TV initial setup is completed... • If you want to scan the channels automatically again. Search for channels p. 38 • If you want to change to another language. Language p. 35 • If you want to change the location setting. Location p. 35 • If you want to restore the picture and sound setting. Picture and sound setup p. 31 • If you want to change the Chromecast built-in TV setting. Chromecast built-in TV setup p. 22 21 .English Installation System searching. Please wait... Auto programming may take more than 20 minutes to complete. Digital channels will take longer than Analog to find and program. Please wait until you see the Auto Programming complete message. Digital channels found: 0 Analog channels found: 0 Total progress: 1 23 Stop 4 10 Use to select your preferred picture setting, then press OK. Please select your preferred picture mode. Skip Standard Vivid Sports 12 11 Use to select your preferred sound setting, then press OK. Please select your preferred sound mode. 1 Skip Standard Vivid Sports 2 12 After TV initial setup is completed, a message will appear if there is a software update available for the TV. Note(s) • If you are not receiving a signal from your cable service, contact the cable provider. • If you press during Autoprogram, this setup of TV channels will be cancelled. • The initial Autoprogram function can be executed for either Antenna or Cable only once. When you change the connection (Antenna / Cable), select Search for channels again. p. 38 Continued on next page.