Philips 65PFL8900 User manual - Page 41

Network settings 1 Press  and use  to select Setup, then press OK. 2 Use    to select Network settings, then press OK. 3 Adjust the following items. Manual network settings 1 Use  to select Manual network settings, then press OK. Manual network settings Network selection Connection test Wireless network setting Setting status IP configuration Home network Proxy configuration Wake-on-LAN(DIAL) Net TV Reset network settings 41 .English Wireless network setting This menu is displayed only when you set Wireless in Network selection. In order to use a wireless network, you must set up a connection to the AP (e.g. wireless router). 2 Use  to select Wireless network setting, then press OK. Auto Search for wireless networks automatically and select the SSID from the list. 3 Use  to select Auto, then press OK. 4 The list of wireless networks will be displayed. Use  to select the appropriate the SSID, then press OK. Auto Manually enter your SSID Router 1 Router 2 Router 3 Router 4 Easy Connect WPS code Manual Network selection 2 Use  to select Network selection, then press OK. 3 Use  to select the desired setting, then press OK. Wired If you connect to an Ethernet cable, select Wired to connect to the internet. Wireless If you have a router with WPS function, select Wireless to connect to the internet. • If you select the SSID with , WEP*2 / WPA / WPA2 Key entry screen will appear. Enter the WEP*2 / WPA / WPA2 key of the selected wireless network using   , then press OK. • If you select the SSID has a WPS, the WPS setting screen will appear. Use    to select a setting, then press OK. Easy Connect Select this setting if your router has a Wi-Fi Protected Setup (WPS) button. Start scanning for wireless networks on the TV after pressing the WPS button on your router. If connection test fails, try Easy Connect again.*1 If it fails then refer to the router's manual for more details. WPS code Select this setting if your router has a WPS but does not have a WPS button. Enter the 8-digit WPS PIN code shown on your TV in the router settings menu via PC before Connect is selected. Manual If your wireless network with authentication setting (WEP*2, WPA or WPA2), WEP*2 / WPA / WPA2 Key entry screen will appear. Enter the WEP*2 / WPA / WPA2 key of the selected wireless network using   , then press OK. *1 WPS (Easy Connect) cannot be used when the security protocol is set to WEP. Change the Access Point's security mode from WEP to WPA or WPA2 (recommended). *2 WEP is not recommended to be used due to its major security flaws. Change the security protocol on the wireless router to WPA or WPA2 (recommended) mode. Confirmation message will appear. Select OK to complete the settings. Note(s) • For a wireless network with authentication setting, key icon appears to the right hand of the SSID. • Signal icon shows the strength of the signal. • WEP*2 / WPA key appears as asterisks on the confirmation screen. • The wireless LAN supports following specifications. -Wireless standards: IEEE 802.1 1 a/b/g/n/ac -Frequency spectrum: 2.4GHz / 5GHz -Security protocol: WEP*2 / WPA / WPA2 Continued on next page.