Philips AZ1025 User manual - Page 10

English DIGITAL TUNER MW (AM) TUNING STEP (SOME VERSIONS ONLY) In North and South America the frequency step between adjacent channels in the AM band is 10 KHz. In the rest of the world this step is 9 KHz. Usually this frequency step has been preset in the factory of your area. To change the tuning step 1. Adjust the CD TUNER TAPE/OFF slider to TAPE/OFF position. 2. Press and hold down on BAND and SEARCH ∞ simultaneously to select 9 KHz. 3. Adjust the CD TUNER TAPE/OFF slider to TUNER position and then release the BAND and SEARCH ∞ controls. ™ All preset stations will be lost and need to be programmed again. • To select 10 KHz, repeat steps 1-3 but use SEARCH § instead. TUNING TO RADIO STATIONS 1. Adjust the CD TUNER TAPE/OFF slider to TUNER position. 2. Press BAND to select your wave band. To tune to radio stations, press the SEARCH or TUNING controls ∞ or § until the frequency in the display starts running, then release the control. ™ Srch appears in the display and the radio automatically tunes to a station of sufficient reception. 3. Repeat if necessary until you find the desired station. • To tune to a weak transmitter, briefly press SEARCH ∞ or § until you have found optimum reception or the correct frequency. ™ When STEREO appears in the display, you are receiving a FM- stereo transmitter. To improve radio reception • For FM, pull out the telescopic antenna. Incline and turn the antenna. Reduce its length if the signal is too strong (very close to a transmitter). • For AM, the set is provided with a built-in antenna so the telescopic antenna is not needed. Direct the antenna by turning the whole set. VOLUME PAUSE S CD SYNCHRO START RECORDIN VOLUME CD SYNCHRO START RECORD FM TUNER SHUFFLE PRESETS REPEAT PROG BAND SHUFFLE AZ1025 TUNER FM 10