Philips AZ102S User manual - Page 10
Power Supply, General Operation
View all Philips AZ102S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Power Supply General Operation Power Supply Whenever convenient, use the power supply cord if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries. 4 Install the unit near the AC outlet and where the AC power plug can be easily reached. • Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms. Children could seriously injure themselves as the free end of the cable may Batteries (not included) still be live if only the connector is removed 1 Open the battery door and insert 6 batteries, type R-14, UM-2 or C-cells, (preferably from the MAINS socket at the back of the unit. alkaline) with the correct polarity as indicated The type plate is located on the bottom by the "+" and "-" symbols inside the of the set. compar tment. Helpful hints: 2 Replace the battery door, making sure the batteries are firmly and correctly in place.The set is now ready to operate. - To avoid unnecessary energy consumption, always adjust the Source selector to OFF after using the set. Batteries contain chemical substances, so they should be disposed of properly. General operation • Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or Switching on and off and selecting the cause the batteries to burst: function • Do not mix battery types: e.g. alkaline with 1 To select your sound source, adjust the carbon zinc. Only use batteries of the same type Source selector to: CD, FM or AM. for the set. • When inserting new batteries, do not try to mix 2 To switch off the set, adjust the Source old batteries with the new ones. selector to OFF position. • Remove the batteries if the set is not to be used 3 To switch to LINE IN mode, connect an for a long time. • Perchlorate Material-special handling may apply. external audio source to the LINE-IN inlet. See www.dtsc.ca.gov/hazardouswaste/perchlorate. Helpful hints: • The set switches to LINE IN mode Using AC power automatically when an external audio source WARNING: Always check you have is connected, no matter the set is in CD, FM completely switched off the set, before or AM mode. you change or disconnect power supply. • The LINE-IN inlet is not for earphones. 1 Check if the power voltage, as shown on Adjusting volume and sound the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or Adjust the sound with the VOLUME and DBB controls. service center. 2 Connect the power cord to the AC MAINS~ inlet and the wall socket.The set is now connected and ready for use. 3 To switch the set off completely, withdraw the power cord from the wall socket.