Philips AZ1065 User manual - Page 5
Basic Functions, General Information - remote control
View all Philips AZ1065 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
English BASIC FUNCTIONS GENERAL INFORMATION Switching on and off 1. Adjust the POWER slider to the desired sound source: CD, TUNER or TAPE/OFF. ™ The respective function indicator: CD, TUNER or TAPE lights up. 2. To switch off, adjust the POWER slider to TAPE/OFF position with the keys on the tape deck released. ™ The respective function indicator: CD, TUNER or TAPE goes out. ™ The volume and tuner presets will be retained in the set's memory. POWEROFTFTAUPNEERCD DBB DYNAMIC BASS BOOST CD PAUSE STOP-OPEN SEARCH Adjusting volume and sound 1. On the set press the VOLUME control to increase or decrease volume (or press + or - on the remote control). ™ Display shows the volume level VOL and a number from 0-32. 2. Adjust the DBB control to select dynamic bass boost on or off. POWEROFTFTAUPNEERCD DBB DYNAMIC BASS BOOST PAUSE STOP-OPEN VOLUME SREENMSOOTRE CD SHUFFLE PHILIPS demo mode 1. On the set or remote control, press the CD STOP 9 button for 5 seconds. SREENMSOOTRE CD SHUFFLE ALL TUNER LBOAWTT ™ After about 30 seconds, PH..IL ..IPS scrolls across the display. MODE TAPE PRESET 2. To return to the current display you can either: • press any function button on the front panel. This interrupts the demo mode for 30 seconds; • • • SEARCH PLAY•PAUSE STOP SEARCH • • • PROG. • press the CD STOP 9 button for 5 seconds. PH..IL ..IPS scrolls once before the demo mode is cancelled. GENERAL INFORMATION General maintenance • Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. • To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. Safety information • Place the set on a hard and flat surface so that the system does not tilt. Make sure there is adequate ventilation to prevent the system from overheating. • The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. 10