Philips AZ1602 User manual - Page 17

English TROUBLESHOOTING WARNING Under no circumstance should you try to repair the set yourself as this will invalidate the warranty. If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to solve a problem by following these hints, consult your dealer or service center. Problem Possible cause No sound, no power VOLUME is not adjusted. Headphone is connected. Power cord is not securely connected. Batteries are dead. Batteries are inserted incorrectly. Trying to change over from AC power to battery supply without removing the plug. No reaction to Electrostatic discharge. operation of any keys Poor radio reception Weak radio signal. Interference caused by vicinity of electrical equipment like TVs, computers, engines, etc.. no or E indication The CD is badly scratched or dirty. No CD is inserted. The CD is inserted upside down. The laser lens is steamed up. The CD skips tracks The CD is damaged or dirty. SHUFFLE or PROGRAM is active. Poor cassette Dust and dirt on the heads, capstans or sound quality pressure rollers. Use of unsuitable cassette types (METAL or CHROME) for recording. Recording does Cassette tab(s) may be snapped off. not work Solution Adjust volume. Disconnect headphone. Connect power cord properly. Insert fresh batteries. Insert batteries correctly. Remove the power plug from the unit's AC MAINS inlet. Disconnect the set from power supply, reconnect after a few seconds. Direct the antenna for optimum reception. Keep the radio away from electrical equipment. Replace or clean the CD. Insert a CD. Insert CD with label upwards. Wait until the lens has cleared. Replace or clean the CD. Switch off SHUFFLE or PROGRAM play. Clean heads, capstans, and pressure rollers. Only use NORMAL type cassettes for recording. Apply a piece of adhesive tape over the aperture. 17