Philips CD1811R User manual - Page 10

3 Get started • the power socket on the wall. English Caution •• Ensure you have read the safety instructions in the "Important" section before you connect and install your handset. Connect the base station Warning •• Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the phone. •• Use only the supplied power adapter to charge the batteries. Note •• If you subscribe to the digital subscriber line (DSL) high speed internet service through your telephone line, ensure you install a DSL filter between the telephone line cord and the power socket.. The filter prevents noise and caller ID problems caused by the DSL interference. For more information on the DSL filters, contact your DSL service provider. •• The type plate is located on the bottom of the base station. 1 Connect each end of the power adapter to: • the DC input jack at the bottom of the base station; • the power socket on the wall. 2 Connect each end of the line cord to: • the telephone socket at the bottom of the base station; • the telephone socket on the wall. 3 Connect each end of the power adapter to (for multi handset version only): • the DC input jack at the bottom of the extra handset charger. Install the handset Caution •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. •• Use only the supplied batteries. •• Risk of decreased battery life! Never mix different brands or types of batteries. Warning •• Check the battery polarity when inserting in the battery compartment. Incorrect polarity may damage the product. The batteries are pre-installed in the handset. Pull the battery tape off from the battery door before charging. EN 9