Philips CDR820BK User manual - Page 14
Power supply
View all Philips CDR820BK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
xp CDR 820/17 eng. 30-08-2001 10:43 Pagina 14 English Installation Digital optical connections via a digital receiver If you have a receiver with digital optical in- and outputs, these connections allow you to make digital recordings from various sources, connected to the receiver. Power supply 3 2 2 DIGITAL RECEIVER CD RECORDER 1 Remove the dust caps from the digital optical connections of both source and CD recorder. Keep the caps in a safe place. 2 Connect an optical fibre-optic cord between the OPTICAL IN- and OUT jacks of the set and optical in- and output jacks on the digital receiver. Make sure you insert both plugs fully, until a click is heard. ➜ Any digital device, connected to the digital input jacks of the digital receiver (e.g. CD and DVD) can now be used as recording source. Digital coaxial connections via a digital receiver If you have a receiver with digital coaxial in- and outputs, these connections allow you to make digital recordings from various sources, connected to the receiver. The type plate is located on the rear of the set. 1 Check whether the power voltage as shown on the type plate corresponds to your local power voltage. If it does not, consult your dealer or service organisation. 2 Make sure all connections have been made before switching on the AC power supply. 3 Connect the power cord supplied to AC MAINS ~ and to the wall outlet.This switches on the AC power supply. 4 Press POWER to switch on the set. ➜ Welcome To PHILIPS Audio will be displayed. 0 Press POWER again to switch off the set. When the set is switched off, it is still consuming some power. To disconnect the set from the power completely, remove the power plug from the wall outlet. Demo mode The demo mode displays various features of the set and will start automatically when no key has been pressed for several minutes or during Standby mode. To cancel demo mode 0 Keep STOP 9 on the set pressed for at least 5 seconds. ➜ The demo mode is cancelled permanently. 1 1 DIGITAL RECEIVER CD RECORDER 1 Connect a digital coaxial cord between the DIGITAL IN- and OUT jacks on the set and e.g. the (digital) AUX in- and output jacks on the digital receiver. ➜ Any digital device, connected to the digital input jacks of the digital receiver (e.g. CD and DVD) can now be used as recording source. 14