Philips DVD170AT User manual - Page 7

STANDARD CONNECTIONS NTSC/PAL SETTING INFRARED REMOTE CONTROL Use the NTSC/PAL switch on the rear of the player to set the player menu according to the standard used by your TV set. To activate the new setting, the player needs to be switched off and on again. NOTE - The video output standard for video CD and DVD-Video discs must correspond to the disc being played. LOADING THE BATTERIES 1 Open the battery compartment cover. 2 Insert two 'AAA' (R03) batteries as indicated inside the bat- tery compartment. 3 Close the cover. HEADPHONES To listen to the player sound directly through headphones, plug the headphone into the headphone jack on the front of the player. Adjust the volume as desired with the headphone volume control. CAUTION Do not mix old and new batteries, and NEVER mix different types of batteries (standard, alkaline, rechargeables, etc.). CONNECTING THE POWER SUPPLY 1 Plug the feed end of the power cord supplied into the Power connector on the rear of the player. 2 Plug the supply end of the cord into an AC outlet. NOTE - The player automatically adjusts to the local AC voltage. - When the player is in the "OFF" position, it still consumes some power. If you wish to disconnect your player completely from the power supply, pull the plug from the AC Outlet. CAUTION Only qualified service personnel should remove the cover or attempt to service this appliance. english 13