Philips FWC798 User manual - Page 15

FWSTANDBY-ON MINI HIFI SYSTEM Basic Functions VOLUME PR G ISNUCRRREODIUBNLDE English ECO POWER EV PRESET N DEMO PLAY• STOP/ PAUSE CLEAR EARCH • TUNIN DISPLAY PROG CLOCK• TIMER AUTO REPLAY DUBBING REC MUSIC LEVEL VOLUME INTERACTIVE VU METER CD 1•2•3 FM •AM CD TUNER SOURCE TAPE AUX TAPE 1•2 CDR / DVD ON •OFF WOOX LEVEL WOOX DYNAMIC AMPLIFICATION CONTROL SOUND NAVIGATION - JOG DSC VAC EXT S IMPORTANT! Before you operate the system, complete the preparation procedures. Plug and Play Plug and Play allows you to store all available radio stations automatically. If Plug and Play has not been installed 1 When you turn on the system, "AUTO INSTALL - PRESS PLAY" will be displayed. 2 Press PLAYÉon the system to start installation. ➜ "INSTALL" will be displayed and followed by "TUNER" and then "AUTO". ➜ PROG will start flashing. ➜ The system will search for all radio stations on the FM band, then the AM band. ➜ All available radio stations with sufficient signal strength will be stored automatically. ➜ The system will stop searching when all the available radio stations are stored or when the memory for 40 preset radio stations is used. ➜ The last preset radio station will play when Plug and Play is completed. To exit without storing the Plug and Play q Press Çon the system. Notes: - When the power is turned on, the disc tray may open and close to initialize the system. - If you do not complete Plug and Play installation, Plug and Play will be reinitiated the next time you turn on the power. - If no stereo frequency is detected during Plug and Play, "CHECK ANTENNA" will be displayed. - During Plug and Play, if no button is pressed within 15 seconds, the system will exit Plug and Play mode automatically. Demonstration mode The system has a demonstration mode that shows the various features offered by the system. To activate the demonstration q In Standby mode, press and hold DEMO STOPÇon the system until "DEMO ON" is displayed. ➜ The demonstration will begin. To reinstall Plug and Play 1 In Standby or Demonstration mode, press and hold PLAYÉon the system until "AUTO INSTALL - PRESS PLAY" is displayed. 2 Press PLAYÉagain to start installation. ➜ All previously stored radio stations will be replaced. To deactivate the demonstration q Press and hold DEMO STOP Çon the system until "DEMO OFF" is displayed. ➜ The system will switch to Standby mode. Note: - Even if you remove the AC power cord and reconnect it to the wall socket, the demonstration will remain off until you activate it again. pg 001-032/C798/37-Eng 15 15 4/16/02, 6:39 PM 3139 115 21261