Philips FWT9200SB User manual - Page 13
Get started
View all Philips FWT9200SB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
4 Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus.The model number and serial number are on the back of the apparatus.Write the numbers here: Model No Serial No Prepare the remote control Note •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. •• Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. To replace the remote control battery: 1 Open the battery compartment. 2 Insert two AAA batteries with correct polarity (+/-) as indicated. 3 Close the battery compartment. Note •• If you are not going to use the remote control for a long time, remove the batteries. •• Do not use old and new or different types of batteries in combination. •• Batteries contain chemical substances, so they should be disposed of properly. Auto install radio stations When you connect power and no radio stations are stored, the unit automatically begins to store radio stations. 1 Connect the unit to the power supply. »» [AUTO INSTALL - PRESS PLAY] (auto install - press the PLAY button) is displayed. 2 Press on the main unit to start installation. »» [AUTO] (auto) is displayed. »» The unit automatically stores radio stations with sufficient signal strength. »» When all the available radio stations are stored, the first preset radio station is broadcast automatically. Set clock 1 In the standby mode, press CLOCK to activate the clock setting mode. »» The 12 hour or 24 hour format is displayed. 2 Press ALB/PRESET+/- repeatedly to select 12 hour or 24 hour format. 3 Press CLOCK to confirm. »» The clock digits are displayed and begin to blink. 4 Press ALB/PRESET+/- to set the hour. 5 Press / to set the minute. EN 11