Philips HTS3450 Quick start guide - Page 1

1 Connect A Placement Proper speakers system placement is important to ensure optimum sound performance. D CA C B D A Place the center speaker above or close to the TV. B Place the subwoofer on the floor, at least one metre away from the TV. C Place the front speakers at equal disctances from the TV. D Place the rear speakers at normal listening ear level. B Connect the radio antennas Keep the antennas away from the electronic devices to prevent unwanted interference. C Connect the speakers to AV subwoofer Connect the various colored plugs from the speakers to the same colored jacks at the rear of the AV subwoofer. REAR REAR RIGHT LEFT FRONT RIGHT CENTER FRONT LEFT OR B L R DVD System (rear) 12 mm C AM A A Connect the FM antenna to the FM jack. Extend the wire and fix its end to the wall. B Unfold the AM/MW loop antenna and fix the claw into the slot. C Push the tabs and insert the wires into the AM/MW jacks. D Connect the AV subwoofer to DVD system Use the supplied inter-connect cable to connect TO AV SUBWOOFER jack and TO DVD SYSTEM jack. Tighten the screws at the sides to secure the connection. AV subwoofer (rear) L AM AM R DVD System (rear) 2 Set up E Connect the DVD system to TV VIDEO IN (CVBS) Television ( rear) VIDEO IN (CVBS) To off-air antenna or set-top box L Pb R AM AM DVD System (rearr) Y Pb A Use the supplied composite video cable to connect the CVBS jack on this DVD system to the VIDEO IN jack on your TV. B Plug in the power cables from the DVD system, AV subwoofer and TV to the AC power outlets. Note It is important to connect the DVD system directly to your TV. F Connect the audio from TV to DVD system (optional) To hear the TV audio through this home theater system, use the red and white audio cables (not supplied) to connect the TV IN (R/L) jacks on this DVD system to the AUDIO output jacks on your TV. Television ( rear) AUDIO OUT AUDIO OUT AUDIO IN AUDIO OUT b L AM AM R DVD System (rear) Note Press TV on the remote control to get the sound output from the speakers system when watching the TV program. A Finding the viewing channel A Press STANDBY ON on the DVD system. B Press SOURCE on the DVD system until "DISC" appears on the display panel. C Turn on the TV. Use the TV's remote control to select the correct viewing channel for the DVD system. You should see the blue DVD background on the TV. Note To search for the correct viewing channel, press the Channel Down button on the TV's remote control repeatedly (or AV, SELECT, ° button) until you see the blue DVD background. If you are using a RF modulator, set the TV to channel 3 or 4. B Select the display language on the screen A Press SETUP. The { General Setup Page } appears. General Setup Page Disc Lock Display Dim Program OSD Language Screen Saver DivX(R) VOD Code English Espanõl Brazil Por B Press T to select { OSD Language } and press X. C Use TS keys to select a language in the menu and press OK to confirm. D Press SETUP to exit. Note The language set here is only for the menus that are shown on the TV while operating this DVD system, not for the DVD disc menu. There are various setup options (Audio Setup, Video Setup, Preference Setup) available on this DVD system. Refer to the user manual for more information.