Philips MCD718 User manual - Page 36

Other Functions English Radio Reception Tuning to radio stations 1 Press ECO POWER/STANDBY-ON B (B on the remote) to switch on the last selected source. 2 Press SOURCE (TUNER on the remote) to select TUNER mode. 3 Press TUNER on the remote again to select the desired band: FM or AM. 4 Press and hold ¡ / ™ (CH on the remote) until the frequency indication starts to change, then release. ➜ The system automatically tunes to the next strong radio station. ● To tune to a weak station, press ¡ / ™ (CH +/à / á on the remote) briefly and repeatedly until an optimal reception is found. 5 Repeat Step 4 if necessary until you find the desired radio station. Presetting radio stations You can preset up to 40 stations (20 in each band) regardless of the reception. Automatic progamming ● Press PROG on the remote for more than two seconds to activate programming. ➜ All available stations are programmed. Manual progamming 1 Tune to your desired radio station (refer to "Tuning to radio stations"). 2 Press PROG on the remote. ➜ "PROG" icon flashes. 3 Press PRESET+ or PRESET-/9 (or CH +/- (¡ / ™) on the remote) to select the desired preset number. ➜ If "PROG" icon goes off before you select the desired preset number, press PROG on the remote. 4 Press PROG on the remote again to store the radio station. ● Repeat steps 1-4 to store other radio stations. Listening to preset radio stations ● In tuner mode, press PRESET+ or PRESET-/9 (or CH on the remote) to select the desired preset number. ➜ The preset number, radio frequency, and waveband are displayed. Setting the clock 1 In Standby mode, press and hold CLOCKon the remote until the time flashes on the display. ➜ "CLOCK SET" is displayed briefly.Then, the hour digits flash on the display screen. 2 Turn VOLUME -/+ clockwise or anticlockwise or press VOLUME +/- on the remote to set the hours. 3 Press CLOCK to confirm. ➜ The minute digits flash on the display screen. 4 Turn VOLUME -/+ clockwise or anticlockwise or press VOLUME +/- on the remote to set the minutes. 5 Press CLOCK again to confirm the clock setting. Notes: - This system only supports 12-hour mode. - The clock setting will be erased when the system is disconnected from the power supply. - The system will exit clock setting mode if no button is pressed within 30 seconds. Setting sleep/wake-up timer Sleep timer setting In power-on mode, the sleep setting enables the system to switch to standby mode automatically at a preset time. 1 In power-on mode, press SLEEP/TIMER on the remote repeatedly to select a preset time. ➜ The selections are as follows (time in minutes): 00 ➜ 10 ➜ 20 ➜ 30 ➜ 40 ➜ 50 ➜ 60 ➜ 70 ➜ 80 ➜ 90 ➜ 00 36