Philips MCM118D User manual - Page 7

Basic Functions OPEN / CLOSE STANDBY-ON SOURCE BAND PROG / CLOCK - VOLUME + TUNING IMPORTANT: Before you operate the system, complete the preparation procedures. Switching the system on ● Press STANDBY-ON (y on the remote control). ➜ The system will switch to the last selected source. ● Press SOURCE (CD, TUNER or AUX on the remote control). ➜ The system will switch to the selected source. To switch the system to standby mode ● Press STANDBY-ON (y on the remote control). ➜ The clock is displayed. To switch the system to Eco-power standby mode ● Press and hold STANDBY-ON (y on the remote control) for more than 2 seconds. ➜ The display will go blank. Power-saving automatic standby The power-saving feature automatically switches to standby 15 minutes after a CD playback has ended and no control is operated. Adjusting volume and sound 1 Press VOLUME - / + to increase or decrease volume. ➜ Display shows the volume level and a number from 0-32. 2 Press DSC repeatedly to select the desired sound effect: JAZZ / POP / CLASSIC / ROCK. VOLUME DBB DSC 3 Press DBB (on the remote control) to switch bass enhancement on or off. ➜ Display shows: DBB if the DBB is activated. 4 Press MUTE on the remote control to stop sound play-back instantly. ➜ Playback will continue without sound and the display shows MUTE . ● To start sound playback you can: - press MUTE again; - adjust the volume controls; - change source. 12 CD/MP3 Operation MICRO SY STEM MCM118D iR TRK POP PROG DBB MP3 CD REP ALL IMPORTANT: The lens of the CD player should never be touched. Loading a disc This CD player plays Audio Discs including CDRecordables, CD-Rewritables and MP3 CD. ● CD-ROM, CD-I, CDV, VCD, DVD or computer CDs, however, are not possible. 1 Select CD source. 2 Press OPEN/CLOSE3 on the top of the system to open the CD compartment. ➜ OPEN is displayed when you open the CD compar tment. OPEN / CLOSE PROG / CLOCK - VOLUME + TUNING 3 Insert a disc with the printed side facing up and press down on OPEN/CLOSE3 to close the CD door. ➜ READ is displayed as the CD player scans the contents of a disc, and then the total number of tracks and playing time (or the total number of albums and tracks for MP3 disc) are shown. Basic playback controls To play a disc ● Press 2; to start playback. ➜ The current track number and elapsed playing time of the track are displayed during disc playback. To select a different track ● Press ¡1 2™ once or repeatedly until the desired track number appears in the display. To find a passage within a track 1 Press and hold down on ¡1 2™. ➜ The disc is played at high speed and low volume. 2 When you recognise the passage you want, release ¡1 2™. ➜ Normal playback continues. To interrupt playback ● Press 2; during playback. ➜ The display freezes and the elapsed playing time flashes when playback is interrupted. ➜ To resume, press 2; again. To stop playback ● Press 9. Notes: CD play will also stop when; - the CD door is opened. - the disc has reached the end. - you select another source: TUNER or AUX. - you select standby Playing an MP3 disc 1 Load an MP3 disc. ➜ The disc reading time may exceed 10 seconds due to the large number of songs compiled into one disc. ➜ "XXX YY" is displayed. XXX is the current track number and YY is the current album number. 2 Press ALBUM 4 3 to select a desired album.. 13