Philips MX5100VR User manual - Page 20

MX5100VR.qxd 6/04/2004 3:37 PM Page 20 20 Video Cassette Playback Read and follow the steps below to play a tape. 1 Turn on the TV. Set it to channel 3 or 4 or its AUDIO/VIDEO IN channel. This depends on how you connected the System to a TV. Details are on pages 8-11. 2 With the System's power off, insert a tape in the cassette compartment. The STANDBY-ON and VCR lights will appear on the front of the System. If the tape's record tab has been removed, playback will start automatically. Or, if the System's power is already on, press VCR to put the System in VCR mode. The red VCR light will appear on the front of the System. 3 If play does not start automatically, press VCR, then press PLAY B. 1 Turn on the TV. 2 Insert a tape in the System. TIMER SET STANDBY-ON SETUP/ AUDIO/ PROG BAND SUBTITLE ANGLE REC DISPLAY ZOOM SKIP/ CH TITLE C-RESET CLEAR MODE/SPEED SKIP/ CH RETURN DVD DISC MENU TUNER VCR OK 3 4 Press STOP C to stop playback. 5 Press REW h to rewind the tape. 6 After the tape stops, press STOP/EJECT CA on the front of the System to remove the tape. 4 5 STOP PLAY REW FF PAUSE SLOW 123 VCR/TV 456 SEARCH MODE 789 REPEAT REPEAT +10 0 A-B SURROUND SOUND VOLUME -+ 6 Press STOP/EJECT CA on the System. Helpful Hints • Other tape playback features are on pages 42-46. • If AUTO REPEAT is ON, playback will begin when you insert a tape, even when the record tab is intact. Details are on page 42. • You must connect the System to a TV using the RF coaxial cable or the audio/video cables in order to use the VCR features.These hookups are explained on pages eight and 11. • You cannot use the VCR when the System is in Tuner mode. If you fast forward, rewind, or eject a videotape, you may hear noise through the speakers or some displays may be incorrect. • You cannot use the Tuner when the System is in VCR mode. Make sure you stop tape play before putting the System in Tuner mode.