Philips MX980D User manual (English) - Page 13

CONNECTIONS English Power The type plate is located on the rear of the receiver. 1 Check whether the power voltage as shown on the type plate corresponds to your local power voltage. If it does not, consult your dealer or service organization. 2 Connect the power cord to the power outlet. To disconnect the unit from the power completely, remove the power plug from the power outlet. Speaker connections Some of the speaker connections on the receiver are screw connectors and some are click-fit connectors. Use them as shown below. 7 mm 1 2 3 8 mm 1 2 3 1 Always connect the colored (or marked) wire to the colored terminal and the black (or unmarked) wire to the black terminal. 2 Connect: - Left front speaker to L (red and black) - Right front speaker to R (red and black) - Center speaker to CENTER (blue and black) - Left surround speaker to SURROUND L (grey and black) - Right surround speaker to SURROUND R (grey and black) TV as the center speaker You may use your Philips TV with CINEMA LINK as the center speaker. For TV's with cinch connectors, additional cinch cables are needed. These cables must be connected to the blue CENTER PRE-OUT connector on the back. Look into the instruction manual of your TV on how to use it as the center speaker. Antenna connections AM (MW) antenna The loop antenna supplied is for indoor use only. Position the antenna as far away as possible from the receiver, a TV, the cables, a DVD player, a VCR and other radiation sources. 1 Fit the plug of the frame antenna to AM LOOP as shown below. 2 Turn the antenna for optimum reception. ANTENNA AM LOOP FM antenna The wire antenna supplied can be used only to receive nearby stations. For better reception we recommend using a cable antenna system or an outdoor antenna. 1 Open the FM 300 Ω click-fits by pushing the lever down as shown below. 2 Insert each wire of the antenna into one hole. 3 Close the click-fits using the lever. 4 Move the antenna in different positions for optimum reception. 8 mm 1 2 3 FRONT AV / GAME cap (FR 975, MX 980D only) • To remove the FRONT AV / GAME cap, press on the right side of the cap. • Insert the cap from below to close the compartment. FRONT AV / GAME PHONES FRONT AV / GAME PHONES The unit complies with the FCC-Rules, Part 15. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. 13