Philips MZ-1100 User manual - Page 23
Troubleshooting
View all Philips MZ-1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
English Troubleshooting WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to solve a problem by following these hints, consult your dealer or service center. Problem The disc is ejected automatically. Radio reception is poor. The system does not react when buttons are pressed. Sound cannot be heard or is of poor quality. The left and right sound outputs are reversed. The remote control does not function properly. The timer is not working. Solution ✔ Load in the disc with label facing right. ✔ Replace or clean the disc, see "Maintenance". ✔ Use a finalized CD-RW or a correct MP3-CD format disc. ✔ If the signal is too weak, adjust the antenna or connect an external antenna for better reception. ✔ Increase the distance between the system and your TV or VCR. ✔ Remove and reconnect the AC power plug and switch on the system again. ✔ Adjust the volume. ✔ Disconnect the headphones. ✔ Check that the speakers are connected correctly. ✔ Make sure the MP3-CD was recorded within 32-256 kbps bit rate with sampling frequencies at 48 kHz, 44.1 kHz or 32 kHz. ✔ Check the speaker connections and location. ✔ Select the source (MP3-CD or TUNER, for example) before pressing the function button (ÉÅ, S, T). ✔ Reduce the distance between the remote control and the system. ✔ Replace the battery. ✔ Point the remote control directly toward the IR sensor. ✔ Set the clock correctly. ✔ Press and hold CLK/TIMER to switch on the timer. 23