Philips SCD530 User manual - Page 12

12 English - When the battery pack is fully charged, the parent unit can be used cordlessly for at least 24 hours. Note:When the parent unit is charged for the first time, the operating time is less than 24 hours.The battery pack only reaches its full capacity after you have charged and discharged it four times. Note:When the parent unit is not in the charger, the battery pack gradually discharges, even when the parent unit is switched off. Using the appliance 1 Place the parent unit and the baby unit in the same room to test the connection (Fig. 11). Make sure the baby unit is at least 1 metre/3 feet away from the parent unit. 2 Press and hold the on/off button 3 on the baby unit until the green power-on light goes on. (Fig. 12) Note:The power-on light always lights up green, even when there is no connection with the parent unit. , The nightlight lights up briefly and then fades out again. , The display lights up and the battery symbol appears on the display (Fig. 13). , After 2 seconds the temperature and humidity values are shown on the display (Fig. 14). 3 Press and hold the on/off button 3 on the parent unit until the sound level lights light up briefly. (Fig. 15) , The display goes on and the battery symbol appears on the display (Fig. 16). , The LINK light flashes red and the message 'Searching' appears on the display. (Fig. 17) , The LINK light on the parent unit turns green and lights up continuously when a connection has been established between the baby unit and parent unit.The message 'Linked' appears on the display. (Fig. 18) , After 2 seconds the message 'Linked' disappears and the temperature and humidity values are shown on the display. (Fig. 19) , The first time you switch on the parent unit, the message 'Language' appears on the display. Select the desired language (see chapter 'Menu options, section 'Setting display language'). (Fig. 20) , If no connection is established, the LINK light on the parent unit stops flashing and lights up red.The parent unit beeps from time to time and the message 'Not Linked' appears on the display. (Fig. 21) Positioning the baby monitor 1 Place the baby unit at least 3 feet/1 meter away from your baby (Fig. 22). 2 Place the parent unit within the operating range of the baby unit. Make sure it is at least 3 feet/1 meter away from the baby unit to avoid acoustic feedback (Fig. 11). For more information on the operating range, see section 'Operating range' below. Operating range The operating range of the baby monitor is 1000 feet/330 meters in open air. Depending on the surroundings and other disturbing factors, this range may be smaller. Indoors the operating range is up to 150 feet/50 meters. Dry materials Material thickness Loss of range Wood, plaster, cardboard, glass (without metal, wires or lead) Brick, plywood Reinforced concrete < 12 in/30cm < 12 in/30cm < 12in/30cm 0-10% 5-35% 30-100%