Philips SHB4000WT User manual - Page 8

3 Get started Charge the headset Warning •• Before you use your headset for the first time, charge the battery for four hours for optimum battery capacity and lifetime. •• Use only the original USB charging cable to avoid any damage. •• End a call before charging the headset, as connecting the headset for charging will power off the unit. Plug the headset into a powered USB port with an USB charging cable. »» LED turns white during charging and turns off when the headset is fully charged. Tip •• Normally, a full charge takes three hours. Pair the headset with your mobile phone Before you use the headset with your mobile phone for the first time, pair it with the mobile phone. A successful pairing establishes a unique encrypted link between the headset and the mobile phone.The headset stores the last eight links in the memory. If you try to pair more than eight devices, the link for the earliest paired devices is replaced by the new link. 1 Make sure that the mobile phone is turned on and its Bluetooth feature is activated. 2 Make sure that the headset is charged and turned off. 3 Press and hold until the LED starts flashing white and blue alternately. »» The headset is in pairing mode, which lasts five minutes. 4 Pair the headset with the mobile phone. For details, refer to the user manual of your mobile phone. A sample pairing is shown below. 1 Activate the Bluetooth feature of your mobile phone, search for the model number of the headset. 2 On mobile phones featuring Bluetooth 2.1+EDR or higher, you do not need to enter a pass code. 3 From the found devices, select Philips SHB4000. • Enter "0000" (4 zeros) if prompted to enter the pin code of the headset. Settings Bluetooth 10:35 Connectivity Add Bluetooth device Select Back 10:36 Settings Devices Found Philips SHB46000 Select Back Settings 10:37 Connectivity Enter Password **** 0000 Select Back 6 EN