Philips SRP1103 User manual - Page 3

CBL/SAT Cable box, satellite receiver, Internet Protocol TV (IPTV), Free To Air TV, High Definition Television decoder (HDTV) and TiVo Example: setting up the universal remote control to operate your TV: 1 Switch ON the TV manually or use the original remote control for this. Tune to channel 1. 2 Press and hold the 5 sec. deviceselection button for 5 seconds until the red Setup light blinks. • The remote control is now in setup mode. 3 Look up the 4-digit code for your brand in the brand list at the back of this user manual. A 4-digit code is shown for each brand. Use the digit buttons to enter the code for your brand. • If the red Setup light turns off, an invalid code was entered. In this case, 5-60SEC. try again. 4 Aim the remote 5 - 60 sec. control at the TV. Press and hold the button. Release it immediately as soon as the TV switches off. • This step normally takes between 5 and 60 seconds. In extreme circumstances this step can take up to 15 minutes. 4 EN 5 Switch ON the TV. Try out the buttons you need for operating it.Try, for example, if the - CH + and digit buttons function properly. • If a button does not work as expected, press and hold that button. Release it immediately as soon as it works. For more information, see chapter 2.2.2. 6 Press the device selection button twice to finish setup. • When no 2 x button is pressed for 5 minutes or more, the remote control will exit setup mode, automatically saving all your settings. Important If you made a mistake: • Press the device selection button twice to exit setup. The red Setup light turns off. • Restart from the beginning. • If the device does not respond at all or not to all of the button commands or if you cannot find the code for your brand, enter '9, 9, 9, 9' in step 3 and continue with step 4.The remote control will now search its full database for a code that works with your TV. Full database search may take up to 15 minutes. 2.2.1 Setting up the remote control for other devices (DVD player / recorder and Cable / Satellite box) 1 Make sure the device is switched on and operational. E.g. insert a disc in the DVD player / recorder. 2 Then follow steps 2 to 6 of 'Setting up the universal remote control to operate your TV'. Make sure to use the correct device selection button: or . EN 5 Getting started English