Philips US2-PM725S User manual - Page 7

PM725.manual 5/27/08 9:23 AM Page 12 Code Indentification CODE IDENTIFICATION 1. Press and hold Code Search button until the red indicator stays on. Release the Code Search button. 2. Press and release the desired mode button (TV, VCR, etc.). The red indicator blinks, then stays lit. 3. Press a release the Code Search button. The indicator light blinks off. 4. To find the first digit for the code stored under the mode key pressed in step 2, press each numeric key from 0-9 in turn. When the indicator light blinks off the number you pressed is the first digit for the code you are searching for. 5. To find the second digit, repeat step 4, this time when the indicator light blinks off this is the second digit. 6. Repeat step 4 again to find the third digit. 2. 1.,3. 4. Sleep Timer The Sleep feature enables the remote to turn off the TV after a period of 1 to 99 minutes. Remote is to be in TV mode to set a Sleep Timer. This feature works even if your TV does not have this feature. 1. Press and release the TV Mode key. 2. Press and hold the Sleep button until LED remains on (occurring after approx. 2-3 seconds). 3. Release Sleep button. 4. Press and release the numeric keys (01-99) for the time required. The LED will blink off to indicate keypress acceptance and remain off after second keypress. 5. TV Sleep Timer now set. 6. Leave the Remote pointing towards the TV with an unobstructed path. To cancel the Sleep Timer, press and hold the Sleep key until the LED blinks or press and release the Power key in TV Mode. Code Learning TIPS ON LEARNING 1. Use fresh batteries for both the Learning Remote and the Original Remote. 2. Perform a Master clear (see page 15) before learning. 3. Place the original remote end-to-end with the Learning Remote so the IR transmitters on both remotes are directly in line with each other. Keep the two remotes approximately one inch away from each other. 4. Experiment by learning 2 or 3 commands initially (to ensure compatibility and familiarity) and then carry out a Master Clear before completely learning your original remote's commands. 5. Do not try to learn directly under an incandescent or low-energy light as these can cause interference with learning. Keep at least three feet away from any such light sources. 1 2 1 3