Pioneer 1014TX-K Service Manual - Page 5

Specifications - vsx remote

Page 5 highlights

5 6 1. SPECIFICATIONS Specifications Amplifier section Continuous average power output of 110 watts* per channel, min., at 8 ohms, from 20 Hz to 20,000 Hz with no more than 0.09%** total harmonic distortion (front). Continuous Power Output Front 110 W + 110 W (20 Hz-20 kHz, 0.09%) Center 110 W (20 Hz-20 kHz, 0.09%) Surround 110 W + 110 W (20 Hz-20 kHz, 0.09%) Surround back ......110 W + 110 W (20 Hz-20 kHz, 0.09%) Audio Section Input (Sensitivity/Impedance) LINE 335 mV/47 kΩ Frequency Response LINE 5 Hz to 100,000 Hz dB Output (Level/Impedance) REC 335 mV/2.2kΩ Tone Control BASS 6 dB (100 Hz) TREBLE 6 dB (10 kHz) LOUDNESS 4/+2 dB (100Hz/10 kHz) (at volume position -40dB) Signal-to-Noise Ratio (IHF, short circuited, A network) LINE 103 dB Signal-to-Noise Ratio [EIA, at 1W (1kHz)] LINE 83 dB * Measured pursuant to the Federal Trade Commission's Trade Regulation rule on Power Output Claims for Amplifiers ** Measured by Audio Spectrum Analyzer Composite Video / S-Video Section Input (Sensitivity/Impedance 1 Vp-p/75Ω Output (Level/Impedance 1 Vp-p/75Ω Signal-to-Noise Ratio 65 dB Frequency Response 5 Hz to 10 MHz dB Component Video Sectio Input (Sensitivity/Impedance 1 Vp-p/75Ω Output (Level/Impedance 1 Vp-p/75Ω Signal-to-Noise Ratio 65 dB Frequency Response 5 Hz to 40 MHz dB FM Tuner Sectio Frequency Range 87.5 MHz to 108 MHz Usable Sensitivity ......... Mono: 13.2 dBf, IHF (1.3 µV/75Ω) 50 dB Quieting Sensitivity Mono: 20.2 dBf Stereo:38.6 dBf Signal-to-Noise Ratio Mono: 73 dB (at 85 dBf) Stereo: 70 dB (at 85 dBf) Distortion Stereo: 0.5% (1 kHz) Alternate Channel Selectivity 60 dB (400 kHz) Stereo Separation 40 dB (1 kHz) Frequency Response 30 Hz to 15 kHz ± 1dB 7 8 A Antenna Input 75Ω unbalanced AM Tuner Sectio Frequency Range 530 kHz to 1,700 kHz Sensitivity (IHF, Loop antenna 350 µV/m Selectivity 25 dB Signal-to-Noise Ratio 50 dB Antenna Loop antenna Miscellaneous B Power Requirements AC 120 V, 60 Hz Power Consumption 480 W, 630 VA In standby 0.43 W AC Outlet switched) 100 W MAX. Dimensions 420 (W) x 173 (H) x 465 (D) mm (16 9/16 (W) x 613/16 (H) x 185/16 (D) in.) Weight (without package 15.5 kg (34.2 lb) Furnished Parts Microphone (for Auto MCACC setup 1 Microphone stand 1 AA/LR6 dry cell batteries 2 Remote control 1 C AM loop antenna 1 FM wire antenna 1 Warranty card 1 These operating instructions 1 Note • Specifications and the design are subject to possible modifications without notice, due to improvements. Cleaning the uni • Use a polishing cloth or dry cloth to wipe off dust and D dirt. • When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers. • Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface. E F VSX-52TX 5 5 6 7 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149

VSX-52TX
5
5
6
7
8
5
6
7
8
C
D
F
A
B
E
1. SPECIFICATIONS
Specifications
Amplifier section
Continuous average power output of 110 watts* per
channel, min., at 8 ohms, from 20 Hz to 20,000 Hz with
no more than 0.09%** total harmonic distortion (front).
Continuous Power Output
Front
.....................
110 W + 110 W (20 Hz-20 kHz, 0.09%)
Center
.................................
110 W (20 Hz-20 kHz, 0.09%)
Surround
..............
110 W + 110 W (20 Hz-20 kHz, 0.09%)
Surround back
......
110 W + 110 W (20 Hz-20 kHz, 0.09%)
Audio Section
Input (Sensitivity/Impedance)
LINE
....................................................
335 mV/47 k
Frequency Response
LINE
.............................
5 Hz to 100,000 Hz
dB
Output (Level/Impedance)
REC
....................................................
335 mV/2.2k
Tone Control
BASS
................................................
±
6 dB (100 Hz)
TREBLE
.............................................
±
6 dB (10 kHz)
LOUDNESS
.......................
+4/+2 dB (100Hz/10 kHz)
(at volume position –40dB)
Signal-to-Noise Ratio (IHF, short circuited, A network)
LINE
................................................................
103 dB
Signal-to-Noise Ratio [EIA, at 1W (1kHz)]
LINE
..................................................................
83 dB
* Measured pursuant to the Federal Trade Commission’s
Trade Regulation rule on Power Output Claims for Amplifiers
** Measured by Audio Spectrum Analyzer
Composite Video / S-Video Section
Input (Sensitivity/Impedance)
...........................
1 Vp-p/75
Output (Level/Impedance)
................................
1 Vp-p/75
Signal-to-Noise Ratio
...............................................
65 dB
Frequency Response
.........................
5 Hz to 10 MHz
dB
Component Video Sectio
Input (Sensitivity/Impedance)
...........................
1 Vp-p/75
Output (Level/Impedance)
................................
1 Vp-p/75
Signal-to-Noise Ratio
...............................................
65 dB
Frequency Response
........................
5 Hz to 40 MHz
dB
FM Tuner Sectio
Frequency Range
...........................
87.5 MHz to 108 MHz
Usable Sensitivity
.........
Mono: 13.2 dBf, IHF (1.3
µ
V/75
)
50 dB Quieting Sensitivity
.........................
Mono: 20.2 dBf
Stereo:38.6 dBf
Signal-to-Noise Ratio
..................
Mono: 73 dB (at 85 dBf)
Stereo: 70 dB (at 85 dBf)
Distortion
...........................................
Stereo: 0.5% (1 kHz)
Alternate Channel Selectivity
....................
60 dB (400 kHz)
Stereo Separation
.........................................
40 dB (1 kHz)
Frequency Response
.....................
30 Hz to 15 kHz
±
1dB
Antenna Input
...........................................
75
unbalanced
AM Tuner Sectio
Frequency Range
..............................
530 kHz to 1,700 kHz
Sensitivity (IHF, Loop antenna)
............................
350
µ
V/m
Selectivity
...................................................................
25 dB
Signal-to-Noise Ratio
.................................................
50 dB
Antenna
.........................................................
Loop antenna
Miscellaneous
Power Requirements
................................
AC 120 V, 60 Hz
Power Consumption
....................................
480 W, 630 VA
In standby
..............................................................
0.43 W
AC Outlet
........................................
(switched) 100 W MAX.
Dimensions
.......................
420 (W) x 173 (H) x 465 (D) mm
(16
9
/
16
(W) x 6
13
/
16
(H) x 18
5
/
16
(D) in.)
Weight (without package)
...........................
15.5 kg (34.2 lb)
Furnished Parts
Microphone (for Auto MCACC setup)
..........................
1
Microphone stand
........................................................
1
AA/LR6 dry cell batteries
................................................
2
Remote control
..................................................................
1
AM loop antenna
...............................................................
1
FM wire antenna
................................................................
1
Warranty card
....................................................................
1
These operating instructions
..............................................
1
Note
Specifications and the design are subject to possible
modifications without notice, due to improvements.
Cleaning the uni
Use a polishing cloth or dry cloth to wipe off dust and
dirt.
When the surface is dirty, wipe with a soft cloth
dipped in some neutral cleanser diluted five or six
times with water, and wrung out well, and then wipe
again with a dry cloth. Do not use furniture wax or
cleansers.
Never use thinners, benzine, insecticide sprays or
other chemicals on or near this unit, since these will
corrode the surface.