Pioneer AVIC N1 Other Manual - Page 30
After Installing the Unit - reset
![]() |
UPC - 012562682952
View all Pioneer AVIC N1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
After Installing the Unit 1. Reconnecting the battery. First, double-check that all connections are correct and that the unit is installed correctly. Reassemble all vehicle components that you previously removed. Then reconnect the negative (-) cable to the negative (-) terminal of the battery. 2. Start the engine. 3. Press the RESET button on the display unit. Press the RESET button on the display unit using a pointed object such as the tip of a pen. 4. Enter the following settings: • Install the programme in the navigation system. • Drive until the initialized sensors start operating normally. • Set the time and language. Set the navigation system as explained in the "Operation Manual" or "Hardware Manual". Note: If you reconnected the Hide-away unit, press the RESET button. After installing the unit, be sure to check at a safe place that the vehicle is performing normally. 29
![](/manual_guide/products/pioneer-avic-n1-manual-50b69da/30.png)