Pioneer AVIC-X920BT Installation Manual - Page 20
Precautions before, installation, To guard against, electromagnetic interference, Before installing - in dash navigation
UPC - 884938104241
View all Pioneer AVIC-X920BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Section 04 Installation Precautions before installation CAUTION ! Never install this product in places where, or in a manner that: - It could injure the driver or passengers if the vehicle stops suddenly. - It may interfere with the driver's opera- tion of the vehicle, such as on the floor in front of the driver's seat, or close to the steering wheel or shift lever. ! Make sure there is nothing behind the dashboard or paneling when drilling holes in them. Be careful not to damage fuel lines, brake lines, electronic components, communication wires or power cables. ! When using screws, do not allow them to come into contact with any electrical lead. Vibration may damage wires or insulation, leading to a short circuit or other damage to the vehicle. ! To ensure proper installation, use the supplied parts in the manner specified. If any parts other than the supplied ones are used, they may damage internal parts of this product or they may work loose and the product may become detached. ! It is extremely dangerous to allow the cables to become wound around the steering column or shift lever. Be sure to install this product, its cables, and wiring away in such a way that they will not obstruct or hinder driving. ! Make sure that leads cannot get caught in a door or the sliding mechanism of a seat, resulting in a short circuit. ! Please confirm the proper function of your vehicle's other equipment following installation of the navigation system. ! Do not install this navigation system where it may (i) obstruct the driver's vision, (ii) impair the performance of any of the vehicle's operating systems or safety features, including airbags, hazard lamp buttons or (iii) impair the driver's ability to safely operate the vehicle. ! Install the navigation system between the driver's seat and front passenger seat so that it will not be hit by the driver or passenger if the vehicle stops quickly. ! Never install the navigation system in front of or next to the place in the dash, door, or pillar from which one of your vehicle's airbags would deploy. Please refer to your vehicle's owner's manual for reference to the deployment area of the frontal airbags. To guard against electromagnetic interference In order to prevent interference, set the following items as far as possible from this navigation system, other cables or leads: ! FM, AM antenna and its lead ! GPS antenna and its lead In addition you should lay or route each antenna lead as far as possible from other antenna leads. Do not bind them together, lay or route them together, or cross them. Such electromagnetic noise will increase the potential for errors in the location display. Before installing ! Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. ! Before making a final installation of this product, temporarily connect the wiring to confirm that the connections are correct and the system works properly. 20 En