Pioneer AVIC-X940BT Installation Manual - Page 22
Installation - parts
View all Pioneer AVIC-X940BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Section 03 Installation ! The cords must not cover the area shown in the figure below. This is necessary to allow the amps and navigation mechanism to dissipate heat. Do not cover this area. ! The semiconductor laser will be damaged if it overheats, so don't install the navigation unit anywhere hot - for instance, near a heater outlet. Installation using the screw holes on the side of the navigation unit % Fastening the navigation unit to the factory radio-mounting bracket. Position the navigation unit so that the brackets screw holes and its screw holes are aligned, and tighten the screws at three locations on each side. Use either the truss head screws (5 mm × 8 mm) or flush surface screws (5 mm × 9 mm), depending on the shape of the bracket's screw holes. Parts supplied Parts marked (*) are supplied with AVICX940BT. If the pawl interferes with installation, you may bend it down out of the way. Factory radio-mounting bracket The navigation unit Truss head screw (5 mm × 8 mm) (6 pcs.) Flush surface screw (5 mm × 9 mm) (6 pcs.) Screw* (2 mm × 4 mm) (1 pc.) Truss head screw or flush surface screw Be sure to use the screws supplied with this navigation system. Dashboard or console 22 En