Pioneer AVIC-Z2 Other Manual - Page 26
Installing the GPS antenna - power cable
UPC - 012562847443
View all Pioneer AVIC-Z2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Installation Installing the GPS antenna • Do not cut the GPS antenna lead to shorten it or use an extension to make it longer. Altering the antenna cable could result in a short circuit or malfunction and permanent damage to the navigation system. Installation notes • The antenna should be installed on a level surface where radio waves will be blocked as little as possible. Radio waves cannot be received by the antenna if reception from the satellite is blocked. Installation on the vehicle roof or trunk lid is recommended to optimise reception. Roof Trunk lid Rear shelf • When installing the GPS antenna inside the vehicle, be sure to use the metal sheet provided with your system. If this is not used, the reception sensitivity will be poor. • Do not cut the accessory metal sheet. This would reduce the sensitivity of the GPS antenna. • Take care not to pull the antenna lead when removing the GPS antenna. The magnet attached to the antenna is very powerful, and the lead may become detached. • The GPS antenna is installed with a magnet. When installing the GPS antenna, be careful not to scratch the vehicle body. • When installing the GPS antenna on the outside of the vehicle, always put it in the vehicle when going through an automatic vehicle wash. If it is left on the outside it may be knocked off and scratch the vehicle body. • Do not paint the GPS antenna, as this may affect its performance. 25